Optimization of machining parameters of Electric Discharge Machining for 202 stainless steel
Journal Title: International Journal of Modern Engineering Research (IJMER) - Year 2013, Vol 3, Issue 4
Abstract
: Electric discharge machining is used for machining of hard materials like steel. In this paper, the effect of electrical discharge machining (EDM) parameters such as pulse-on time (TON), pulse-off time (TOFF), and current (I) on material removal rate (MRR) in 202 stainless steel was studied. The experiments are carried out as per design of experiments approach using L27 orthogonal array. The results were analyzed using analysis of variance and response graphs. From this study, it is found that different combinations of EDM process parameters are required to achieve higher MRR and greater surface finish. Signal to noise ratio (S/N) and analysis of variance (ANOVA) is used to analyze the effect of the parameters on MRR and also to identify the optimum cutting parameters. The contribution of each cutting parameter towards the MRR is also identified.
Authors and Affiliations
Singh Jaspreet
Keywords
Related Articles
- EP ID EP146581
- DOI -
- Views 93
- Downloads 0
To make a biogas energy from different sources & creating awareness between human begins – case study
Biogas from biomass appears as an alternative source of energy, which is potentially enriched in biomass resources. This article gives an overview of present and future use of biomass as an industrial feedstock...
Statistical Performance Analysis Routing Algorithms for Wimax - Wi-Fi Integrated Heterogeneous Network
Abstact: To provide uninterrupted service to every subscribe in a wireless network, there is a need to incorporate a low cost, flexible heterogeneous network which can able to couple any kind of network for effici...
An Improvement to Sensor Protocol for Information via Negotiation (SPIN) Protocol
Wireless sensor network is collection of one or more homogeneous or heterogeneous sensor nodes which sense some events and inform sink for that by sending that data towards it to perform some action. Data transmi...
Flow Physics Analysis of Three-Bucket Helical Savonius Rotor at Twist Angle Using CFD
Abstract: In this research work the flow behavior was analyzed, which affect the power coefficient as well as torque coefficient of a helical Savonius rotor is investigated by means of commercial code CFD. Conventi...
Numerical Characterization of the Pores and the Determination of the Point Of Crack Initiation in Some Cast Aluminum Alloys
Abstract: Porosity is a major defect in cast aluminum alloys affecting in particular, the fatigue strength. In this work, fractal analysis of the pores in the microstructure of cast aluminum alloys were done to pro...