A Concept for Application of Hall Sensors in Measurement of Magnetic Field over Magnetic Catapult Tracks
Journal Title: Problemy Mechatroniki. Uzbrojenie, lotnictwo, inżynieria bezpieczeństwa - Year 2019, Vol 10, Issue 2
Abstract
The growing demand for commercial unmanned aerial vehicles (UAV) requires that innovative technical solutions for the critical aspects of UAV servicing, must be researched. The magnetic catapult discussed in this work is an interesting alternative to the existing UAV deployment or launch platforms. This paper presents the research designed to facilitate the measurement and analysis of the position of a launch truck applied in a UAV magnetic catapult with tracks. The measurement system discussed herein comprised a transducer connected to Hall sensors which were spaced evenly at the base of a superconductor pod. A displacement of the superconductor pod relative to the magnetic field resulted in the variation of the voltage output from individual Hall sensors. A proprietary algorithm was developed and controlled stepper motors which displaced the assembly of the superconductor pod with the Hall sensors along the test track of the UAV magnetic catapult. At the same time as the displacement was sensed by the Hall sensors, they were reading the real-time magnetic strength; it was therefore critical for the microcontroller, which executed the control algorithm, to operate at a sufficient processing frequency (speed). The proprietary control algorithm was executed by an ATMEL ATmega2560 RISC processor. The processor system read the status of every Hall sensor in the assembly and compared it to the reference voltage outputs stored in the microcontroller’s memory. The difference between the voltage output reading and the reference voltage outputs and the superconductor pod’s geometry was used to determine the superconductor pod’s position along the magnetic tracks of the UAV magnetic catapult.<br/><br/>
Authors and Affiliations
Sławomir CZUBAJ, Anna SIBILSKA-MROZIEWICZ, Edyta ŁADYŻYŃSKA-KOZDRAŚ
Keywords
Related Articles
- EP ID EP599498
- DOI 10.5604/01.3001.0013.2116
- Views 101
- Downloads 0
Badania wpływu kąta uderzenia 7,62 mm pocisku pistoletowego z rdzeniem ołowianym i płaszczem stalowym na penetrację wkładów balistycznych aramidowych i polietylenowych
W artykule zaprezentowano wyniki badań próbek wkładów podstawowych do kamizelek kuloodpornych. Prace ukierunkowane były na określenie wpływu kąta uderzenia pocisku na wartość granicy ochrony balistycznej. Stosowano 7,62...
Research of Fragmentation of Dynamic Compressed Samples Made of Composites Cu-W-BNα
Research of the compression impact test of samples made of sintered cermets Cu-W-BNα with different contents of ceramics phase namely 0,5; 1, 1,5 i 3% (wt.) have been presented in this paper. The compression test were ca...
Czasoprzestrzeń w analizie dynamicznej mostów
W pracy zaprezentowano kolejne zastosowania i możliwości analizy dynamicznej obiektów inżynierskich za pomocą czasoprzestrzeni z wykorzystaniem różnic skończonych, w ujęciu numerycznym zaproponowanym przez autora. Obiekt...
Major Conditions of Shooting Range Operation in Poland
Under the "Authorisations of the Minister of National Defence" (latest - No. 57/MON dated 22 December 2014), a Permanent Expert Team operates at the Institute of Armament Technology of the Faculty of Mechatronics and Aer...
Laboratory Setback Activators and Explosive Suitability for Gun Launch
There is currently no agreed standard methodology for assessing the suitability of explosives for gun launch or for the determination of acceptance criteria for explosive fill defects. Laboratory setback activator testin...