A Design of New Brands of Martenzite Steels by Artificial Neural Networks
Journal Title: Analele Universitatii "Dunarea de Jos" din Galati. Fascicula IX, Metalurgie si Stiinta Materialelor - Year 2011, Vol 34, Issue 3
Abstract
The paper proposes a model-based approach for the design of martenzite structure steels with improved mechanical and plastic characteristics using proper composition and thermal treatment. For that purpose, artificial neural models approximating the dependence of steels strength characteristics on the percentage content of alloying components were trained. These non-linear models are further used within an optimization gradient procedure based on backpropagation of utility function through neural network structure. In order to optimizing the steel characteristics via its chemical composition, several steel brands with high values of tensile strenght, yield strenght and relative elongation were designed. A steel composition having economical alloying and proper for practical application was determined comparing several obtained decisions. The usage of that steel will lead to lightening of the hardware for automobile industry.
Authors and Affiliations
Yavor LUKARSKI, Sasho POPOV, Nikolay TONCHEV, Petia KOPRINKOVA-HRISTOVA, Silvia POPOVA
Keywords
Related Articles
- EP ID EP625966
- DOI -
- Views 101
- Downloads 0
Mathematical Model for the Optimization of Preparation and Delivery Flows at LBC Adjustment
In the paper, the mathematical model of the sheet metal rolls handling process was realized in the LBC Adjustment section of Arcelor Mittal S.A. Galati. Mathematical modeling is performed by statistical methods, namely a...
Influence of Secondary Refining Treatments on the Quality of HighGrade Steel Used in Oil and Gas Industry
Steel is the most important alloy used in oil and gas industry from production and processing to the distribution of refined products. In this research is analyzed the production technology of steel intended for long pip...
The Influence of Cold Rolling on the Microstructure for Drawing Steels
The paper presents the structural changes that appeared in steel for deep drawing, as a result of cold rolling and of recrystallization thermal treatment. The research was conducted on samples taken from the rolled strap...
Optimisation of Refractory Components of Sliding Gate Mechanism for Continuous Casting
New design techniques have been developed to optimize refractory components of sliding gate mechanism for continuous casting of steel. The overall objective is to increase CC productivity as well as steel quality by usin...
Influence of Thermal Treatment on Zirconia Powder
Zirconia powder in amorphous state was prepared by electrolytic deposition method (ELD) and then it was subjected to a thermal treatment according to a typical diagram. The structural changes in zirconia powder induced b...