A Review of Piston Compression Ring Tribology
Journal Title: Tribology in Industry - Year 2014, Vol 36, Issue 3
Abstract
This paper presents studies related to piston compression ring tribology and the theoretical and experimental works developed to analyze ring-liner contact friction. The literatures revealed that the simulation and experimental work are more independently investigated. The correlation of modeling output with experimental output is presented in limited number of research works. The experimental work to capture data from a running engine is also in basic level.
Authors and Affiliations
P. C. Mishra
Keywords
Related Articles
- EP ID EP158122
- DOI -
- Views 102
- Downloads 0
Some Developments in Triboanalysis of Coated Machine Components
Surface engineering and coatings on surfaces of various auto- and machine components, bearings, piston rings, etc. have been since years proved to be a successful way of improving their performance [1-7]. However, qualit...
Wear and Degradation Modes in Selected Vehicle Tribosystems
The wear and degradation mechanisms of two principle vehicle tribosystems are presented to elucidate the main causes of their premature failure. The first case study concerns the malfunction of an automotive cast iron pr...
Frictional Response of Lubricant in EHL Contact under Transient Bi-directional Shear Loading
Consideration of performance, efficiency and energy consumption is nowadays an inherent part of the design of every modern machine. These factors are mainly determined by mechanisms taking place within the lubricated con...
Neutral Radius Value Determination by Numerical Simulation Method at Ring Upsetting Test
Ring upsetting represents a basic operation for bulk forming process and has particular significance since it is used for contact friction determination. At ring upsetting by flat dies, metal flow depends upon tribologic...
Analysis and Optimization of Turned Surfaces of AISI 1060 using ANOVA and Regression
AISI 1060 carbon steel for turning process is used to find out best cutting parameters using Analysis of Variance (ANOVA) and Regression Concept. Optimization of cutting parameters in turning operation is analyzed in thi...