Aluminium Cutting Specific Issues
Journal Title: RECENT - Year 2011, Vol 12, Issue 33
Abstract
In this paper the difficulties of cutting pure aluminium, used mainly in large electrical contacts of high voltage equipment are presented. It can be noted that during the cutting without cutting liquid, at certain regimes, the chips are glued on the channel of the front face, remaining there and blocking the channel and cutting edge, so that accidents occur. Also, different forms of chips resulted after cutting with different regimes, indicating in each set of chips used in the cutting regime are studied. The microscopic images of chips, as seen from the outside and from the area that came into contact with cutting edge of bit are shown. The deposition under the cutting edge of bit after cutting at different cutting regimes and different geometrical parameters of used drawknife are presented. Images of cutting edges are given with elements of chips on them and microscopic images where the variation of deposit thickness and edge clearance are shown.
Authors and Affiliations
Iulian POPESCU, Cristina PASCU
Keywords
Related Articles
- EP ID EP113859
- DOI -
- Views 65
- Downloads 0
Procedures and Documents from the Laboratory for Testing of Products to Obtain the Certificate of Participation of the Single European Market
Standardization is a prerequisite for creating an optimal order in the economy and social life of each country. It is an integral part of science, as any science to manufacture certain products is based on standardized t...
Romanian Academic Inventics in 2001-2010 Years
Humanity has always been a knowledge-based society and has evolved as such. This feature prevails during contemporary period and is explicitly recognized. According to the law, inventions, utility models, trademarks, des...
A Generalized Newton-Euler Algorithm for Dynamic Simulation of Robot-Manipulators with Revolute Joints
This article describes a procedure used to compose a set of second order differential equations in order to simulate dynamics of a multi-body manipulator's arm with revolution joints. The procedure is based on d'Alambert...
On Top Riser Working
In the case of castings that have a hotspot at the, top riser are normally used in industrial practice. It is envisaged that the hotspot is very close to the riser. It is considered that the liquid alloy flows more easil...
Theoretical Aspects on some Mechanical and Tribological Properties of MeNx (Me = Ti, Zr, Ta) Thin Films
This paper presents a bibliographical study concerning the mechanical and tribological properties of MeNx type (Me = Ti, Zr, Ta) coatings. Various researches have shown that these types of MeNx compounds revealed good pr...