An Investigation of Comparative Study in Connecting Rod by using Finite Element Analysis
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2018, Vol 8, Issue 1
Abstract
Most of the automobile parts are connected with the help of connecting rod. More vibration occurs on the engines. This project deals with reducing the vibration and calculates the natural frequency of the engines. The top end of the connecting rod is connected with the bottom of the piston and the other end is connected to the bottom of the crankshaft. The crankshaft rotates some amount of energy transfers through connecting rod. The connecting rod and crankshaft are transfer few rotation motion to the piston. The piston is moving transverse direction, so it is necessary to find out natural frequency. The result of this research deals with the natural frequency of two different materials, namely Cast iron and stainless steel. The design of connecting rod is done with the help of CATIA V5R17 and modal analysis is done with the help of Ansys software. The result of model analysis i.e. natural frequency of two different materials is compared and results tell that the natural frequency of cast iron is less in comparison to stainless steel. Where the deformation in cast iron takes place in the10th layer of the node, whereas the deformation takes place in stainless steel in 8th layer itself. By this comparison, it is justified that natural frequency, i.e. deformation in cast iron is less in comparison with stainless steel
Authors and Affiliations
R. RAMESH KUMAR, M. SENTHIL KUMAR, MATHEW ALPHONSE
Keywords
Related Articles
- EP ID EP279133
- DOI 10.24247/ijmperdfeb201826
- Views 96
- Downloads 0
Optimization of Elastomeric Passive Engine Mount Using Direct Optimization Method
An ideal engine mount should be able to completely isolate the engine vibration which is caused due to the engine Noise, Vibration and Harshness characteristics. Vibration in an automobile is due to different parts of th...
DMATM: Dual Modified Adaptive Technique Based Multiplier
The most critical arithmetic functional units are digital multipliers. This system overall performance is depends on the throughput, of the multiplier. An n-bit by n-bit multiplier can be employed by an n-bit by n-bit mu...
Graph Based Classifier to Detect Malicious URL
Malicious attack is a major issue in cyberspace. The criminal obtains vital information like username, password, and Credit/Debit card numbers, from the victims through deception. Various detection solutions are proposed...
Comparison of Wall Temperatures on Scramjet Inlets at Hypersonic Velocities
Skin frictions produced at high operational speeds generate lots of heat on the surface of the aircrafts. It is very much essential to determine the quantity of the heat produced on the outermost layer of the vehicle dur...
The Experimental Studies of Heat Transfer and Friction Factor in a Roughened Solar Air Heater using Arc Rib Geometries
Solar air heater utilizes rib roughness to enhance heat transfer. Experimental investigation has been conducted to study heat transfer and efficiency improvement in solar air heater using the arc rib roughness. Rib rough...