Analysis of dynamics and prediction of reliability indicators of a cooling thermoelement with the predefined geometry of branches
Journal Title: Восточно-Европейский журнал передовых технологий - Year 2018, Vol 5, Issue 8
Abstract
<p>We have investigated the influence of structural and technological elements on the basic parameters, reliability indicators, and the dynamics of operation of thermoelectric cooling devices under various current modes within the operating range of temperature differences. We analyzed the ratios of correlation between the time required to enter a stationary mode and relative intensity of failures in a cooler, and energy indicators, thermoelectric parameters of thermoelements, structural and technological indicators.</p><p>An analysis of the time required to enter a stationary mode was performed for different modes of operation from the maximum cooling capacity to the minimum failure rate. It is shown that in order to reduce the time required for a cooler to enter a stationary mode, at the predefined geometry of thermoelements and temperature difference, it is necessary to employ the mode of maximum cooling capacity.</p><p>The quantitative analysis showed that at the predefined geometry of thermoelements branches the time required to enter a stationary working mode does not depend on the number of thermoelements in a thermoelectric cooler. At a difference of temperatures close to the maximum value, the time required to enter a stationary working mode differs slightly for all modes of operation. Comparative analysis of the basic parameters of reliability indicators and dynamical characteristics makes it possible to find compromise solutions when constructing thermoelectric devices taking into consideration the weight of each of the constraints.</p><p>From a practical point of view, the results obtained suggest that increasing the cooling rate does not require changes to the existing technology for making thermoelectric coolers. Control over performance speed during transition from one stationary state to another state is executed through the selection of current modes in the operation of a thermoelectric device. In this case, there is a possibility to choose the conditions under which reliability indicators match the permissible limit.</p>
Authors and Affiliations
Vladimir Zaykov, Yurii Zhuravlov, Dmitry Mescheryakov
Keywords
Related Articles
- EP ID EP528204
- DOI 10.15587/1729-4061.2018.123890
- Views 72
- Downloads 0
A study of initial stages for formation of carbon condensates on copper
<p>In the CVD method, samples of carbon condensates were obtained under special conditions (low substrate temperature and short growth times). The use of special technological conditions makes it possible to study the in...
X-ray diagnostics of the structure of nearsurface layers of ionimplanted monocrystalline materials
A method for obtaining information on the distribution of the parameters of a crystalline structure in the thickness of a near-surface ion-implanted layer, types and characteristics of radiation defects (size, concentrat...
Establishment of heatexchange process regularities at inflammation of reed samples
<span lang="EN-US">The conducted studies into the influence of induction period on reed inflammation have established the mechanisms of the process of heat transfer to material which makes it possible to influence this p...
Development of a method for determining the area of operation of unmanned vehicles formation by using the graph theory
<p class="a">The results of research into influence of modification of the topology of a heterogeneous formation of unmanned vehicles on the area, covered by this formation are presented. We proposed an approach, accordi...
Establishing the patterns in the formation of oxide films on the alloy Ti6Al4V in carbonic acid solutions
This paper reports results of studying the features of the formation of thin interference-colored oxide films on the alloy Ti6Al4V alloy in solutions of carboxylic acids. It has been established that a change in voltage...