ANALYSIS OF THE STRUCTURE AND TRIBOLOGICAL PROPERTIES OF SINTERED STAINLESS STEELS
Journal Title: Tribologia - Year 2017, Vol 272, Issue 2
Abstract
Increasing development of civilization encourages the search for modern engineering materials. At present, very interesting and promising materials are sintered stainless steels that are considered to be the most rapidly developing group of materials, which is related to the demand for materials with good mechanical properties and high resistance to corrosive agents. Taking into account sintered austenitic–ferritic steels, it is possible to obtain a structure with different proportions of the two basic structural components. The main problem limiting the applicability of sintered stainless steels is porosity, which deteriorates not only the strength properties but also the usability as compared to their cast and materials after plastic working. Extremely valuable factors influencing tribological properties are the chemical composition, proportion of individual powders and sintering conditions. In this study, the microstructure and tribological properties of sintered stainless steels obtained by sintering in different proportions of 316L austenitic steel and 409L ferritic steel were compared. The abrasion wear resistance test for individual sintered steels was performed by pin-on-disc method.
Authors and Affiliations
Barbara LISIECKA, Agata DUDEK, Katarzyna STRZELCZAK
Keywords
Related Articles
- EP ID EP239702
- DOI -
- Views 70
- Downloads 0
LUBRICATING OIL INFLUENCE ON FATIGUE STRENGTH OF BEARING ALLOYS
An influence of three kinds of lubricating oils on the fatigue strength of a slide layer made of AlSn11Cu1,2 bearing alloy has been investigated under conditions of various values of temperature and loading ratio κ. Obje...
ANALYSIS OF THE LOAD-CARRYING CAPACITY OF A HYDRODYNAMIC WATER-LUBRICATED BEARING IN A HYDROELECTRIC POWER PLANT
The paper presents an analysis of the load-carrying capacity of a historic hydrodynamic water-lubricated radial bearing of an unconventional segment design installed in the Braniewo Hydroelectric Power Plant. The aim of...
PROBLEMY TRIBOLOGICZNEGO CHARAKTERYZOWANIA SKOJARZEŃ OBUWIE–PODŁOŻE
Charakterystyki tribologiczne podeszew obuwia w skojarzeniu z podłożem są parametrami istotnymi z punktu widzenia bezpieczeństwa jego użytkowania oraz czasu eksploatacji. Metody badania współczynnika tarcia i zużycia sto...
MODELLING THE TRIBOLOGICAL PROPERTIES OF MINERAL OIL WITH ANTI-WEAR AND ANTI-SEIZURE ADDITIVES
The article presents the results of experimental research of mineral oils with the anti-wear and anti-seizure additives. The experiments were designed in accordance with two methods, namely: the designs of experiments fo...
EXPERIMENTAL STUDIES ON THE INFLUENCE OF ABRASIVE MATERIALS ON THE WEAR OF HARD-WEARING STEELS
The paper presents the wear properties of hard-wearing steels and structural steels used in mining and transport machines exposed to the aggressive action of the environment, which have been determined experimentally in...