Analytical description of the expansion of wall jets of different curvature
Journal Title: Вентиляція, освітлення та теплогазопостачання - Year 2019, Vol 29, Issue
Abstract
The work is devoted to an analytical study of the expansion of wall jets on a convex and concave surfaces (curved semi-limited jets). Such jets have different characteristics depending on the curvature of the surface - from long-range to fast-decay. This makes them one of the most promising areas of increasing the efficiency of air exchange in rooms for various purposes. However, today they have not widespread introduction, which is because of the instability of the development of the jets. The problem is eliminated by using the correct shape of the air outlet duct. To determine the expansion of the jet, an approach has been developed to the analytical description of curved wall jets using the geometric analysis of their turbulent macrostructure. This structure is represented in the form of a sheet of tangent large-scale vortices (puffs). To effectively solve the obtained equations, the Anderson-Björk method was improved. The results show a slight expansion of concave jets and much faster for convex ones. Calculations showed the presence of a critical section with the rapid expansion of a convex jet and the subsequent increased rate of its expansion. Also, a cross section for separation of the jet is obtained. If the slot width is less than 0.15 ... 0.2 of the radius of the wall, then the angle of passage of the jet is significantly reduced, which reduces the expansion of the jet and complicates the design of the multi-slot air distributors developed at the Department of Heat and Gas Supply and Ventilation of Kiev National University of Construction and Architecture.
Authors and Affiliations
V. Mileikovskyi
Keywords
Related Articles
- EP ID EP648498
- DOI -
- Views 75
- Downloads 0
Investigation of Single-Phase Non-Isothermal Filtration in the Geothermal Circulation Systems
In this article, there are geometric model of geothermal porous layer, basic assumptions that accept computational similar systems and thermophysical model of motion and heat transfer of fluids in porous solids. The geom...
The Heat Flux оf The Condenser іn the Improved System of Exhaust Gas Heat Recovery
The authors show the need to improve the proposed earlier basic version of the system of the heat utilization from the exhaust gases of rotary ovens in the direction of more rational use of the available temperature pote...
Estimation of Energy Consumption of Ventilation and Air Conditioning Systems
Requirements for modern air conditioning systems must include a calculation of their power consumption for the entire summer. Manufacturer show characteristic SEER, which is an indicative value and does not reflect the a...
Experimental Research of the Exergy Efficiency of Water Heat Networks and Heating Systems
A study of the exergy efficiency and a procedure for calculating the exergy efficiency has been carried out, depending on the conditions of operation of the heat supply networks and the temperature of the outside air, ba...
Fossil fuel usage issues and ways to deal with
The article discusses the problems associated with the dynamics of growth in the consumption of energy fuels – the shortage of energy resources and the growth of the load on the environment by harmful substances, which a...