ANALYZING THE EFFECT OF HEATED WALL SURFACE TEMPERATURES COMBUSTION CHAMBER DEPOSIT FORMATION
Journal Title: Journal of Mechanical Engineering Research & Developments (JMERD) - Year 2018, Vol 41, Issue 4
Abstract
One of the most important studies on using diesel fuel is the basic study of combustion chamber deposits in engines. These studies were conducted to investigate the effects of deposits on the engine and how deposits are formed in engines. Deposits in the combustion chamber are proven to be formed through three different stages: (1) the condensation of components in incomplete combustion process on the combustion chamber walls; (2) the interaction of unburned fuel droplets; (3) fuel flow (intake valve and nozzle). This paper aim is establishing a correlation between deposits formation on the wall surface when fuel droplets interact with heated wall surfaces and surface temperatures. The changes of heated surface temperature impacted on the interaction of fuel elements with the surface, the evaporation and the dryness or wetness of fuel. In addition, in this study, zones of temperature with greater or lesser deposition formation were also identified. This helps to clarify the complex fluctuations in the deposits combustion chamber in real diesel engines.
Authors and Affiliations
Van Viet Pham
Keywords
Related Articles
- EP ID EP434706
- DOI 10.26480/jmerd.04.2018.17.21
- Views 78
- Downloads 0
THE FAULT LOCATING SYSTEM OF THE HIGH-SPEED MAGLEV TRAIN
Analyzing and researching the levitation and guidance sensor fault location system of high-speed maglev train, we developed an offline testing method of sensor fault location system, which can carry on the fast positioni...
A NUMERICAL STUDY OF THE TURBULENCE MODEL INFLUENCE ON A SAVONIUS WIND TURBINE PERFORMANCE BY MEANS OF MOVING MESH
This numerical research has investigated the influence of the turbulence model on a Savonius wind turbine performance. The numerical simulation has been applied by using two-dimensional analysis of Computational Fluid Dy...
A STUDY ON THE FACTORS AFFECTING THE FLARE OF THE WELD WHEN WELDING THE STEEL WIRE
In this study, an equation for adjusting the parameters affecting the flare of the weld on the welding product was established. Based on the empirical research results, the factors affecting welding flux after using bend...
EFFECT OF ANISOTROPIC MATERIAL ON THE GEOMETRIC NON-LINEAR PERFORMANCE ANALYSIS OF SMART LAMINATED COMPOSITE PLATE INTEGRATED WITH DISTRIBUTED AFC PATCHES
The present study focuses on the effect of anisotropy on thin laminated composite plates as smart structure with distributed AFC patches using ACLD treatment, and analysis is carried out for geometrically nonlinear trans...
MIXING IN TURBULENT COAXIAL JET
This paper studies the mixing process in a compressible turbulent coaxial jet, using a Large Eddy Simulation (LES) type approach. Two cases were considered: Case 1, a passive scalar injected into the annular jet and Case...