APPLICATION OF X-RAY DIFFRACTION AND BARKHAUSEN NOISE ANALYSIS FOR STABILITY CONTROL DURING MACHINING
Journal Title: Materials Engineering - Materialove inzinierstvo (MEMI) - Year 2011, Vol 18, Issue 2
Abstract
The contribution is focused on the recent experience of X-ray Diffraction Laboratory of the Czech Technical University in Prague and Department of Machining and Assembly of the Technical University of Liberec with industrial applications of X-ray diffraction residual stress measurement and Barkhausen noise analysis. Both methods are used for control and optimization of technological parameters during final surface machining of camshafts. They verify whether the required level of residual stresses in given subsurface areas was achieved and serve also as a fast output inspection of machine parts´ surface quality.
Authors and Affiliations
Kamil Kolařík, Nikolaj Ganev, Jan Jersák
Keywords
Related Articles
- EP ID EP97454
- DOI -
- Views 158
- Downloads 0
QUANTITATIVE METALOGRAPHY OF HEAT TREATED ŽS6K SUPERALLOY
Alloy ŽS6K is former USSR superalloy used in DV – 2 jet engine. It is used for turbine rotor blade and whole cast small sized rotors with working temperature up to 800 ÷ 1050°C. This alloy was evaluated after annealing a...
UTILIZATION OF STEREOLOGY FOR QUANTITATIVE ANALYSIS OF PLASTIC DEFORMATION OF FORMING PIECES
Mechanical working leads to final properties of forming pieces, which are affected by conditions of production technology. Utilization of stereology leads to the detail analysis of three-dimensional plastic deformed mate...
Static and dynamic tensile characteristics of DP600 steel sheets
Dynamic tensile testing of sheet steels is becoming more important. Experimental dynamic tensile technique is depending on the strain rate. Each serves for a specific range of strain rates and provides specific type of i...
STRUCTURAL DEGRADATION OF HETEROGENEOUS WELDED JOINTS
Developing the techniques of welding materials with higher dynamic strength onto the rolling surfaces of rails is one of the options for increasing their operational endurance. The subject of this paper is an analysis of...
MICROSTRUCTURE AND MECHANICAL PROPERTIES DEGRADATION OF CrMo CREEP RESISTANT STEEL OPERATING UNDER CREEP CONDITIONS
In this contribution microstructure degradation of a steam tube is analysed. The tube is made of CrMo creep resistant steel and was in service under creep conditions at temperature 530°C and calculated stress level in th...