Aspects of making of a composite material when using red mud
Journal Title: Восточно-Европейский журнал передовых технологий - Year 2018, Vol 2, Issue 6
Abstract
<p class="21">A composite material was developed with the polymeric binder at the elevated concentration of a technogenic raw material, 75 % by weight of red mud, as the filler. Dependence of indicators of composite properties on the content of the filler at the differentiation of varieties of polymer binders was established. When applying the binder Acronal 290 D, the water absorption minimum is 3.2–3.5 % by weight, the maximum is 5.0–5.3 % by weight. When applying Pliolite AC-4, the water absorption minimum is 0.83–0.96 % by weight, the maximum is 3.0–3.2 % by weight. When replacing the binder from the aqueous dispersion with the varnish dispersion, it is observed that water absorption level decreases by two times, but the character of dependence of this indicator on concentration of the filler remains unchanged. Analysis of hydrophobicity as a factor of improvement of operational properties of the composite showed that the maximum values of wetting angle of 130–136 degrees are registered at the concentration of the filler of 75 % by weight.</p><p>We established features of the porous structure of the composite as a factor of influence on its properties. Total porosity and development of its varieties depend on the type of the polymeric binder. Indicators of total porosity are at the level of 9.3–11.8 % against 8.6–23.9 %, and the indicators of open porosity are at a significantly lower level of 0.96–3.15 versus 3.49–5.32 over the same range of changes in the concentrations of the filler when using Pliolite AC-4 compared to Acronal 290 D.</p><p>It was shown that the developed material is distinguished by decorative (red color) and physical-technical characteristics that are important for modern architecture, which contributes to solving comprehensively the tasks on extending the range of composites and on the industrial waste disposal.</p>
Authors and Affiliations
Liubov Melnyk, Valentin Svidersky, Lev Chernyak, Nataliia Dorogan
Keywords
Related Articles
- EP ID EP527887
- DOI 10.15587/1729-4061.2018.125702
- Views 61
- Downloads 0
Optimized smoothing of discrete models of the implicitly defined geometrical objects' surfaces
<p>When using many modern methods of automatic generation of surface meshes of implicitly defined geometric objects, the accuracy of approximation in the vicinity of surface singularities (holes, breaks, etc.) is lost. T...
Investigation of the combination of ITO/CdS/CdTe/Cu/Au solar cells in microassembly for electrical supply of field cables
<p>Studies aimed at optimizing the design of micromodules based on ITO/CdS/CdTe/Cu/Au photoelectric converters, which are used in autonomous power plants for field camps, have been carried out. To use photoelectric conve...
Development of adaptive combined models for predicting time series based on similarity identification
<p>Adaptive combined models of hybrid and selective types for prediction of time series on the basis of a program set of adaptive polynomial models of various orders were offered. Selection in these models is carried out...
Survey of characteristics of dairy-protein concentrates in the low-temperature storage process
<p>The influence of low-temperature refrigeration treatment on the structure and organoleptic parameters of milk-protein concentrates (MPC), obtained with the use of cranberry and viburnum purees, was determined and anal...
Development of methods to improve noise immunity in the fifthgeneration mobile networks based on multiposition signals
<p>We have examined technologies for building 5 G mobile networks, which should provide for the creation of ultradense networks in order to render high-quality services. A formalized statement of the problem on synthesis...