Bending strength and deformability of multilayered glass plates with different types of glass
Journal Title: Вісник Одеської державної академії будівництва та архітектури - Year 2017, Vol 1, Issue 69
Abstract
The cohesion of steel and composite fittings with wood through epoxy adhesive has been investigated. Experimental samples of plankglued prisms were tested for the removal of glued fittings. After experimental research, the dependencies between the pulling load and the unscrewing end of the armature were loosened. The analysis of the test results during which the method of calculating the required length of the rod anchoring of the fittings through an epoxy adhesive in the wood, taking into account the stress in the fittings and the strength of the wood for cutting, was obtained. A sufficient convergence of theoretical calculations with experimental data is found, which allows to recommend the presented method of calculation for the design of reinforced wooden structures. For full use of the strength of the fiberglass and fiberbasalt fittings, it is necessary to use additional anchorages or increase the corrugation of the surface of the composite fittings and secure attachment of these ribs to the body of the fittings.
Authors and Affiliations
B. G. , Demchyna, M. I. , Surmai, A. B. , Peleh, Y. M. , Shydlovskyy
Keywords
Related Articles
- EP ID EP327322
- DOI -
- Views 122
- Downloads 0
Low-emission multi-component cements in the building mortars technology
The main directions of the low-cost economy roadmap in the cement industry are considered. It is shown that the production of special low-emission multicomponent cements provides the realization in cement industry of pro...
Calculation of design heat loading of building heating systems by european and domestic methods
On the example of the residential building with a heated basement floor in Rivne, the design heat load of heating system was calculated using national standard SNiP 2.04.05-91 * and according to European standard EN 1283...
New method of soil tests with piles by load relaxation method
The stress relaxation method is recommended as one of the rapid soil tests with piles in the State standard of Ukraine. There is a number of contradictions and conditional assumptions in the instruction that prevent its...
Calculation of flat bottom tanks, as shells of rotating rigidity rotation
This article includes actions for definition internal forces and moments of thin-walled circular silo for the storage of particulate solids. Wall sheeting of tower silo loaded symmetrical loads. It is assumed, that norma...
Stressed - deformed condition cylindrical metallic shell on a piecewise - standing elastic basis at temperature climatic influence
The previous executed researches of the tense-deformed condition of a vertical metal thin cylindrical shell lying inside on the elastic Winkler foundation under temperature climatic influences are continued in this work....