Bond Quality, Mechanical and Physical Properties of Wood - Polyethylene Reinforced Plywood
Journal Title: International Journal of Engineering Innovations and Research - Year 2018, Vol 7, Issue 5
Abstract
An experimental study has been carried out to investigate the quality of adhesion, mechanical and physical properties of plywood produced from bonding Eucalyptus wood veneers with polyethylene (LDPE) sheet as a reinforeced material. All plywood samples were assessed by physical and mechanical strength tests and the results were recorded. The results are matched with the requirements of plywood for general purpose as per Indian standard IS 303: 1989. The results showed that the reinforcement of wood veneers with polyethylene sheets proved to be intact and showed good strength properties. Overall it proved that bonding of wood veneers with polyethylene (LDPE) sheets can be achieved to produce plywood which may be used for general purpose.
Authors and Affiliations
Ramesh Karri, et al.
Keywords
Related Articles
- EP ID EP498093
- DOI -
- Views 95
- Downloads 0
Nitrogen Oxide Emission from HCCI Combustion using Palm Oil Biodiesel Blended with RON 97 as Fuel
This paper presents nitrogen oxide analysis in modified diesel engine to get homogenous charge compression ignition (HCCI) combustion. In effected of fuel blending value used in te...
Empty Fruit Bunch Spreader Machine: Machine Concept
Empty Fruit Bunch Spreader machine (EFBM), is an attempt to transform manuring EFB concept in plantation. EFBM main objective is to ‘manure’ the whole EFB at frond path with distribute evenly as per layer and width same...
Using Run-of-mine Tonnage and Grade to Predict Cost and Categorize Gold Mines
This paper focuses on establishing logistic model of cost effect of run-of-mine tonnage and grade in the justification of categorization of gold mines. Gold mines could be categorized based on the abilities of rom-grade...
Stability Study of LQR and Pole-Placement Genetic Algorithm Synthesized Input-Output Feedback Linearization Controllers for a Rotary Inverted Pendulum System
The rotary inverted pendulum (RIP) has a fourth order nonlinear dynamics, and its control is typically with two stages, i.e., a swing-up control and a balancing control. For Linear-quadratic regulator (LQR) control, unde...
Developed Regression Models of Mining Rate Fit on Resource and Reserve Variations in Gold Mining
Mining rate determines profitability of a mine and when set at an optimal rate generates maximum NPV. Although mining rate depends on many parameters, ore tonnage has been used as the main determinant of mining rate in t...