CALCULATION OF THE EQUIVALENT ELECTRICAL PARAMETERS OF THE INDUCTOR OF INDUCTION CHANNEL FURNACE WITH DEFECTS IN ITS LINING
Journal Title: Електротехніка і Електромеханіка - Year 2018, Vol 0, Issue 4
Abstract
Aim. The aim of the paper is to determine a quantitative relationship between measured impedance of the inductor and the electrical characteristics of the separated melt circuit parts for the determination of the place of a liquid metal leakage and for the improvement in such way the diagnostic system of lining state of induction channel furnaces. Technique. The study was performed on the basis of the concepts of theoretical electrical engineering, mathematical physics, and mathematical modeling. Results. Using two equivalent electrical circuits of the inductor the analytical expressions and graphical dependencies, which determine a quantitative relationship between the parameters of the separated parts of a liquid-metal circuit and the impedance of the whole inductor measured in practice, for the presence of different lining defects, were found. The method for calculating the increments of equivalent electrical parameters of the inductor as a function of increments of the parameters of the secondary liquid-metal circuit was proposed. Scientific novelty. It is proved that for small changes (less than 10 %) of the parameters of the liquid-metal circuit, it is expedient to use a linear relationship between its increments and to create the sensitivity matrix, which clearly shows the presence of a strong or weak interrelation between the disturbed values of the parameters of the secondary circuit and the inductor. Practical significance. The use of this technique allows to develop the database for various types of lining defects for a given furnace and on its basis to predict the places of a melt leakage and the state of furnace lining owing to periodical measurements of the inductor parameters.
Authors and Affiliations
O. D. Podoltsev, V. M. Zolotaryov, M. A. Shcherba, R. V. Belyanin
Keywords
Related Articles
- EP ID EP491116
- DOI 10.20998/2074-272X.2018.4.05
- Views 84
- Downloads 0
MECHANICAL CHARACTERISTICS OF THREE-PHASE INDUCTION MOTORS WITH SINGLE-PHASE POWER SUPPLY
Aim. Development of a method for calculating mechanical characteristics of three-phase induction motors with single-phase power supply. Methods. The developed algorithm is based on the high-adequacy mathematical model of...
CAST-FILM POLYMER COMPOSITION DOSING SYSTEM DRIVE CONTROL
Object parameters providing uniformity of polymer composition outflow from the spinneret to the substrate are analyzed. An approach to drive controller construction for a dosing system comprising a lag element is conside...
APPLICATION OF A RELATIVE TECHNICAL LEVEL INDEX METHOD TO INDUCTION MOTOR OPTIMIZATION PROBLEMS
On the basis of a method of relative technical level indices with relative geometric controlled variables, analytical expressions are derived to determine the optimum geometric dimensions of the squirrel-cage induction m...
COMPUTING EXPERIMENTS FOR CALCULATION OF ELECTROSTATIC AXISYMMETRIC FIELD IN PIECEWISE-HOMOGENEOUS INSULATION WITH SPHERICAL INCLUSIONS
Calculations of electrostatic axisymmetric field are made with application of solution to Fredholm integral equation of the first and the second kinds in a piecewise homogeneous isotropic linear polymeric insulation. On...
INVESTIGATION OF MECHANICAL STRESSES IN THE DRIVE SHAFT OF MV VACUUM CIRCUIT BREAKER
Introduction. In the last 10-15 years a dominant position in the market of medium voltage circuit breakers, vacuum circuit breakers have taken in which as an actuator mono- or bistable actuators with permanent magnets ar...