CHARACTERISTICS OF SPECIALIZED SINGLE-PHASE HIGH VOLTAGE DOUBLER RECTIFIER
Journal Title: Електротехніка і Електромеханіка - Year 2018, Vol 0, Issue 5
Abstract
Introduction. To obtain a high voltage direct current, voltage multipliers with a number of cascades of three or more are widely used. At the same time, for voltage levels of 100…200 kV there are several advantages of using a specialized single-phase high voltage doubler rectifier. Problem. The main difficulty is that at the moment mathematical modeling has not been worked out for describing modes that use the built-in R, C-filter, as well as a nonlinear load in the form of Zener diodes. Goal. Generalization of the results of the authors' previous publications on the development of an analytical method for calculating the modes of a typical high-voltage direct current installation based on a specialized single-phase voltage doubler rectifier. Methodology. Compilation of a system of algebraic linear and nonlinear equations that describe the current and voltage modes in the elements of a typical high-voltage direct current installation with a nonlinear load. Results. It is shown that with the use of linearization of the current-voltage characteristics of Zener diodes used in the load circuits of a typical high-voltage direct current installation, an analytical solution for the voltages and currents in its elements can be obtained. Originality. The theoretical basis of the complex solution of the system of equations for the currents, voltages and power of the elements of a typical high-voltage direct current installation with the account of nonlinear pulsations is formulated for the first time. Practical value. The obtained theoretical results can be used for calculations, design, optimization of the modes for a wide range of high-voltage direct current installations of technical, technological, and measuring purposes in the range up to 100...200 kV.
Authors and Affiliations
V. O. Brzhezytskyi, R. V. Vendychanskyi, Ye. O. Trotsenko, Ya. O. Haran, O. M. Desyatov, V. I. Khominich
Keywords
Related Articles
- EP ID EP494961
- DOI 10.20998/2074-272X.2018.5.09
- Views 90
- Downloads 0
THE PROBLEM OF CORRECT CHOICE OF FERRITE BEADS
A ferrite bead is a passive electrical element used to suppress high-frequency noise in electric circuits. This is one of the simplest and the cheapest type of filters. Thus, such filters are widely used in electric and...
THE ABSORPTION CHARACTERISTICS OF THE PHASE AND ZONE PAPER-IMPREGNATED INSULATION OF POWER CABLE AT DIRECT VOLTAGE
Introduction. The moral and physical deterioration of medium voltage power cables with phase and zone paper-impregnated insulation requires implementation of quality systems and reliable nondestructive electric diagnosti...
OPTIMAL CONTROL OF THE ELECTRIC SHIPS’ PROPULSION MOTORS DURING REVERSAL
Introduction. Reliability and safety of electric ships’ maneuverability depends on the maneuvering characteristics of their propulsion motors (PM). Therefore, the issues of improving the process of controlling propulsion...
GENERATOR ON ARCADYEV-MARX SCHEME WITH PEAKING OF THE PULSE FRONT IN ITS CASCADES FOR FOOD DISINFECTING
Purpose. To obtain experimentally that the duration of the high-voltage pulse front is less than 1.5 nanoseconds on the load of a pulse voltage generator of less than 50 ohms in the form of more than two working chambers...
ESTIMATING THE LIMIT POSSIBILITIES OF THE STEP CHARGING SYSTEM FOR CAPACITIVE ENERGY STORAGE
The aim of the article is to estimate the limit possibilities of step-by-step charging the capacitive energy storage which are caused by the achievement of a balance among the processes of the receiving and losing of ele...