Collision-free trajectory planning for mobile manipulators subject to control constraints
Journal Title: Archive of Mechanical Engineering - Year 2014, Vol 0, Issue 1
Abstract
A method of planning collision-free trajectory for a mobile manipulator tracking a line section path is presented. The reference trajectory of a mobile platform is not needed, mechanical and control constraints are taken into account. The method is based on a penalty function approach and a redundancy resolution at the acceleration level. Nonholonomic constraints in a Pfaffian form are explicitly incorporated to the control algorithm. The problem is shown to be equivalent to some point-to-point control problem whose solution may be easier determined. The motion of the mobile manipulator is planned in order to maximise the manipulability measure, thus to avoid manipulator singularities. A computer example involving a mobile manipulator consisting of a nonholonomic platform (2,0) class and a 3 DOF RPR type holonomic manipulator operating in a three-dimensional task space is also presented.
Authors and Affiliations
Grzegorz Pajak, Iwona Pajak
Keywords
Related Articles
- EP ID EP166584
- DOI 10.2478/meceng-2014-0002
- Views 105
- Downloads 0
Tracking control of a balancing robot – a model-based approach
This paper presents a control concept for a single-axle mobile robot moving on the horizontal plane. A mathematical model of the nonholonomic mechanical system is derived using Hamel’s equations of motion. Subsequently,...
Simulation of moving loads in elastic multibody systems with parametric model reduction techniques
In elastic multibody systems, one considers large nonlinear rigid body motion and small elastic deformations. In a rising number of applications, e.g. automotive engineering, turning and milling processes, the position o...
Experimental and numerical investigation of radial forces acting on centrifugal pump impeller
The paper presents the results of measurements and predictions of radial thrust in centrifugal pump with specific speed n_s = 26. In the pump tested, a volute with rectangular cross-section was used. The tests were carri...
Influence of high pressure and high temperature hydrogen on fracture toughness of Ni-containing steels and alloys
The effect of hydrogen on short-term strength, low-cycle durability and planestress fracture toughness of 10Cr15Ni27 steel, 04Cr16Ni56 and 05Cr19Ni55 alloys at pressure up to 35 MPa and temperature 293. . . 773 K was inv...
Semi-analytical solution of functionally graded circular short hollow cylinder subject to transient thermal loading
In this paper, by using a semi-analytical solution based on multi-layered approach, the authors present the solutions of temperature, displacements, and transient thermal stresses in functionally graded circular hollow c...