COMPARATIVE ANALYSIS OF DISPERSION COMPENSATION USING ELECTRONIC DISPERSION COMPENSATION TECHNIQUES AT DIFFERENT BIT RATES USING SINGLE MODE FIBER
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2018, Vol 8, Issue 3
Abstract
The performance in the fiber optical communication is majorly limited by a phenomenon called dispersion which generally starts growing after 2Gbps data rate. The pulse gets widened as they travel down the fiber. This widening results in dispersion and other non-linearity. Pulses at the output overlap with the neighboring pulses and cause ISI (Inter-Symbol Interference). Distinct techniques are available to lessen the effect of dispersion like DCF, FBG, and electronic equalization. This paper focuses on reducing dispersion present in optical links by using adaptive equalization. To monitor and suppress the chromatic dispersion, simulations are performed using electronic equalizer at 20, 25 and 30Gbps. A comparison is made between the three data rates and found that maximum Q-Factor is attained at 20Gbps. Outcomes from the simulations show the overall improvement in the signal quality.
Authors and Affiliations
Keywords
Related Articles
- EP ID EP377053
- DOI -
- Views 91
- Downloads 0
Compare the Experimental Performance of V-shaped Black Cotton and Jute Cloth Floating Wicks Solar Stills in Indian Climatic Condition
The single basin single slope conventional solar still gives less amount of distillate output. Therefore, some modifications are proposed for conventional solar still in order to improve the performance and increase the...
COMPARING IMPACT BEHAVIOR OF NATURAL FIBER WITH TERMITE MOUND AND EGG SHELL FILLER ADDED REINFORCED COMPOSITE
Natural fibers are biodegradable and eco-friendly materials which are available in vast. At present days researchers focus more on using natural fiber for the fabrication of new materials with different properties and pr...
Optimization of Process Parameters on Thrust Force and Delamination Factor in Drilling of Carbon Fiber Reinforced Composites
The major objective of this work was to investigate a statistical model, based on Taguchi technique and to estimate the quality of drill in CFRP composite material prepared by hand layup technique. The design of experime...
Design and Development of Microstrip Sensor with Triple Frequency for Determination of Rice Grains Moisture Content
The micro strip moisture sensor is designed and developed with triple frequency, for determination of rice grain moisture content at 4.9GHz, 6.7GHz and 8GHz, with good return loss, as well as good bandwidth. The numerica...
CFD Simulation of Solar Loading in Car
A frequent problem faced by the car drivers in Chennai is, the hot suffocating inner of the car following hours of steady solar radiation when parked in an un-shaded area. The heat build-up in the cabin due to solar radi...