Comparison of extractability of Cd, Cu, Pb and Zn with sequential extraction in contaminated and non-contaminated soils
Journal Title: International Journal of Environmental Science and Technology - Year 2007, Vol 4, Issue 2
Abstract
Various extraction procedures were employed for measuring extractable concentrations of potential toxic elements in soil. The extractability of Cd, Cu, Pb and Zn in four contaminated and four non-contaminated soils of Japan, was compared by single extraction (CaCl2, DTPA, NH4Cl, 0.1 M HCl and 1 M HCl ) and sequential extraction procedures [(six operationally defined chemical phases, viz. water soluble (F1), exchangeable (F2), carbonate (F3), oxide (F4), organic (F5) and residual (F6) fractions)]. Extractability of metals from soils samples varied depending on metals and/or extractants used. Among the extractants, 1 M HCl extracted the largest proportion of Cd (79 to 96% of total), Cu (61 to 83%), Pb (51 to 99%) and Zn (23 to 52%) from soils followed by 0.1 M HCl, NH4Cl, DTPA and CaCl2. In all the extractants, the proportion of extractability of metals was higher in the contaminated soils than the non-contaminated soils. Regardless of soils and extractants, relative extractability was higher for Cd as compared to other three metals. The use of 1 M HCl may be recommended for first-level screening of soil contamination with heavy metals. The other four weak extractants are believed to provide a better assessment of bioavailable/mobile metals content in soils than 1 M HCl extractant. However, 0.1 M HCl mobilized all four metals irrespective of soil types, therefore, might be the best choice if only one extractant is to be used. The sequential extraction procedures showed 22 to 64% of total Cd was in the mobile fraction (sum of F1 to F3), while the corresponding values for Cu, Pb and Zn in this fractions were 2 to 23% suggesting higher mobility of Cd than other three metals. The single extraction procedures are simple and easy to perform and obtained results are comparable with sequential extraction procedure.
Authors and Affiliations
M. A. Kashem, B. R. Singh, T. Kondo, S. M. Imamul Huq, S. Kawai
Keywords
Related Articles
- EP ID EP118488
- DOI -
- Views 103
- Downloads 0
Adsorption of hexavalent chromium from aqueous solutions by wheat bran
In this research, adsorption of chromium (VI) ions on wheat bran has been studied through using batch adsorption techniques. The main objectives of this study are to 1) investigate the chromium adsorption from aqueous so...
Influence of parent material on the contents and distribution of B and Zn in upland soils of Bauchi State, Nigeria
A study was conducted to determine the influence of parent material on the contents and distribution of boron and zinc in soils of Bauchi State, Nigeria. Fourty nine, 30, and 20 top 0-30cm soil samples developed from bas...
Assessment of cement’s dust impact on the soil using principal component analysis and GIS<br />
To evaluate the impact of the cement’s dust emitted by the eastern Moroccan cement factory (Oujda Holcim) and deposited on the soil of the Ain Lahjar commune, 58 samples of soil were collected around the factory on a rad...
Removal of hydrogen sulfide by zinc oxide nanoparticles in drilling fluid
Hydrogen sulfide is a very dangerous, toxic and corrosive gas. It can diffuse into drilling fluid from formations during drilling of gas and oil wells. Hydrogen sulfide should be removed from this fluid to reduce the env...
Assessment of Cd concentration of crude oil polluted arable soils
Thirty soil samples were analyzed for their properties and cadmium concentration in polluted and unpolluted sites of Isikwuato, Abia State, Nigeria. Polluted soils were more acidic (pH = 4.38) than unpolluted ones (pH =...