Comparison Study of Wear Resistance in Reciprocating Compressors for Small Cooling Machines
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2019, Vol 9, Issue 1
Abstract
In this paper, we analyzed the corrosion resistance indicators for (HR) category compressors in comparison of other types of open compressors indicators (open type) and half open (semi-hermetic sealed) that used for the same purpose. An experimental test for corrosion resistance components of these compressors was used. These tests were conducted on the various compressors in similar conditions which allowed achieving this comparison. The different effects of wear resistance on compressor components in terms of design parameters and operating parameters were studied, such as the Frequency of the shaft, number of cylinders, the type and location of the shaft, the specific pressure, the sliding speed of the compressor, type of main bearing, the initial roughness of surfaces friction, the initial clearance in the fits, the type of refrigerant and lubricating oil. HR type compressors generally possess a higher degree of resistance to wear, which provides operational life about 37,000 hours. However, in these compressors, they cannot meet equal wear resistance in Plug-arm and rotating column. The increase in wear resistance in friction surfaces allows an increase in the operational life of the compressor
Authors and Affiliations
Jehad S. Radaideh
Keywords
Related Articles
- EP ID EP463877
- DOI 10.24247/ijmperdfeb201929
- Views 66
- Downloads 0
An Efficiency Analysis of Combined Cycle Power Plants Using DEA Models: A Case Study in Bangladesh
The purpose of this research was to analyse the operation efficiency of existing combined cycle power plants in Bangladesh and identify potential areas for efficiency improvement. This study proposed the application of d...
Evaluation of Composite Laminated by Stacking Sequence with Tio2-Al2o3 Nanocomposite
This paper investigates the effect of titanium oxide and aluminium oxide on Kevlar fiber. The TiO2 and Al2O3 are mixed with epoxy at the ratio of 1:2 and they are applied on the lamina to fabricate the laminate by vacuum...
Effect of Chevron on the Decay Characteristics of Compressible Round Jet
In the present study, the flow fields generated by two jets with a chevron and a conventional circular nozzle exits are studied and compared. Three different nozzle configurations were considered one with no chevron and...
Stylistic Design Engineering (SDE) for an Innovative Green Vehicle Following QFD and TRIZ Applications
With this article, we intend to set the first strategic phase of the product development process, that is to say the one related to the conceptual project. In particular, this work refers to the installation of the proje...
PHYSICAL SIMULATION FOR HOT ROLLING POLICY OF ELECTRICAL SI–STEELS
The present work is dealing with three Si-steel alloys. Representative samples were taken and machined from the as- cast ingots to suite the thermo mechanical simulator. The physical simulation process consists of heatin...