Concerning the Automatic Computation of the Electrical Stresses in the High Voltage Substations during the Transient Regimes
Journal Title: ANALELE UNIVERSITATII DIN CRAIOVA - Seria Inginerie electrica - Year 2017, Vol 41, Issue 41
Abstract
This paper deals with an automatic computation program using a Matlab graphical user interface GUI useful to compute electrical stresses which appear in the high voltage substations; that means the parameters computation of the short circuit currents or transient recovery voltages which appear during the fault regimes in the high voltage networks. The numerical evaluation of the electrical stresses is carried out for the high voltage substations from ST Craiova such as transmission lines Filiasi, Slatina, Turnu Magurele, Isalnita. The parameters of the shortcircuit currents or over voltages are computed and graphical display of their variation in time can be available also. The influence of the high voltage network characteristics, such as the line length or the phase angle of the source voltage on the computed parameters level is pointed out. The Matlab GUI is developed based on the automatic computation program, which was achieved within the research contract with the Transelectrica SA Transport Branch Craiova. The partial results obtained within the above mentioned contract were previously presented in the various papers. Also, the computation algorithm is based on the results presented in the references of this paper. This GUI can be applied for any other high voltage substation whose rated parameters are known.
Authors and Affiliations
Maria Brojboiu, Virginia Ivanov
Keywords
Related Articles
- EP ID EP264068
- DOI -
- Views 103
- Downloads 0
USING A LABVIEW AND FIELD POINT I/O MODULE FOR CATALYTIC ISOTOPIC EXCHANGE COLUMN CONTROL AND OPERATORS TRAINING
This paper presents the main advantages of using the programmable automation controller (PAC) and LabVIEW software in the operation of an isotopic exchange column which is part of ETRF (experimental tritium removal facil...
Aspects Regarding Influences of Voltage and Resistant Torque on Asynchronous Motors Operation
In this paper there are analyzed a series of dynamic regimes that occur in the case when a phase of an asynchronous motor is accidentally interrupted and in the case when the resistant torque increases by step. For...
MODULAR TRANSVERSAL FLUX TUBULAR MACHINE – PRESENTATION AND PROGRESS ACHIEVEMENTS
This paper proposes an interesting new type of tubular machine that can work like a tubular motor or a tubular generator. The machine’s topologies for both operating regimes are presented here. In the paper a prototype o...
Improving Efficiency of DWT Analysis through Faster Interpolation Methods and Multithreading Techniques
The paper deals with techniques to accelerate the DWT power quality analysis. A brief description of a nonspline interpolation schematic is provided firstly. It is used for the evaluation of the first components...
MONITORING SYSTEM FOR THE LOCAL LAUNCH POINTS OF THE ANTI-HAIL UNITS
This paper presents a system for monitoring an anti-hail system. It is proposed a specific system for anti-hail network in Romania witch completes the known systems with information subsystems specific for both to identi...