Condensation and Radiation Modeling Of an Automotive Headlamp
Journal Title: International Journal for Research in Applied Science and Engineering Technology (IJRASET) - Year 2015, Vol 3, Issue 4
Abstract
An automotive headlamp is disclosed to heat fluctuation together with low air exchange the chances of humidity entering the headlamp will therefore enhance the risk for condensation to form on the inner surface of the lamp. The automotive firm today is considerably competitive and tends to focus more on reducing expenses. The consumers demanding high advanced features and styling characteristics likewise transparent optical plastics and low energy dissipating lamps. Because of these reasons dew is formed and it will cause visibility problem from outside. Thus it is of great importance for the car manufactures to be able to simulate the condensation before in the design stage and thereby also reduce the cost. This work describes the performing thermal flow simulation on headlamp by using Computational fluid dynamics (CFD) to calculate the dew point temperature. Thus the dew point temperature is correlated with the values found out from analytical methods.
Authors and Affiliations
Yuvaraj. C, Sangeetha N, Ashok Kumar. R, Naveenkumar U
Keywords
Related Articles
- EP ID EP20134
- DOI -
- Views 259
- Downloads 6
Improving Performance of Diesel Engine with Reduction of Emissions by Applying Magnetic Field
I.C. engine used in automobiles has a problem of pollutant emission, which mainly depends on combustion process occurs in I.C. engines. Incomplete combustion produces large amount of emission gases & gives lower efficie...
slugA Review Paper On Firewall
A firewall is a software that establishes a security perimeter whose main task is to block or restrict both incoming and outg oing info rmation over a network. These firewalls are basically...
Furans & Dioxins(FD) need to fixed with higher interest rate for sustainable tomorrow
Dioxins are a group of closely related tricyclic chlorinated aromatic chemical compounds which are produced as a result of burning of chlorinated substance the most common practice is during incineration of PVC(Poly-Vin...
Experimental Investigation of Industrial by - Products Concrete Filled Mild Steel Tubular Columns with GFRP Wrapping
Concrete filled steel tubular columns are becoming widely used in engineering. Composite structural members provide a cost-effective alternative to traditional structural steel or reinforced concrete columns. The use of...
Review of Developments in Pin-On-Disc Tribometer for Environment Control
The design of earlier pin-on-disc tribometer mainly focuses on normal pressure and environmental conditions and aim to measure the effect of load and speed on material performance. The effect of gas pressure and environ...