Contributions in the Preparation and Processing of Composite Material Type Silumin 3 - Reinforced Matrix with S235JR Steel Mesh
Journal Title: Analele Universitatii "Eftimie Murgu" Resita. Fascicula de Inginerie - Year 2015, Vol 22, Issue 1
Abstract
In the paper are presented concrete data on developing technological batches of metal composite material (MCM) type Silumin 3-reinforced matrix with steel mesh S235JR, with the indicating of the parameter and of the distinct stages of work. The samples from prepared batches were cut along and across by water jet abrasive process and were subjected to a destructive testing program and microstructural examination, obtaining results in concordance with the desired quality. The abrasive material used for cut was GMA granite with the average mesh of 80, the particle size ranging between 150-300 μm, density 2300 kg/m3 and melting point 1240°C.
Authors and Affiliations
Remus Belu-Nica, Relu-Costel Ciubotariu
Keywords
Related Articles
- EP ID EP448787
- DOI -
- Views 73
- Downloads 0
Coil Springs Layer Used to Support a Car Vertical Dynamics Simulator and to Reduce the Maximum Actuation Force
A Danaher Thomson linear actuator with ball screw drive and a real-time control system are used here to induce vertical displacements under the driver/user seat of an in-house dynamic car simulator. In order to better su...
A Comparative study about the Influence of Vibration on Elbow Joint Mobility
The results shown in [1] have referred to a particular appreciation of the elbow joint mobility of a subject to the action vibrations produced by a fitness device. Experiments - performed on four subjects - were held at...
Acoustical Wave Propagation in Sonic Composites
The goal of this paper is to discuss the technique of controlling the mechanical properties of sonic composites. The idea is to architecture the scatterers and material from which they are made, their number and geometry...
X-Y Pen Plotter Design Accomplished from Older Drives
The paper describes the design and the implementation of a small, easily operable and flexible 2-axis CNC pen plotter (Computer Numerical Control). It is accomplished from two old and available CD-ROM (Compact Disc Read-...
HydroHillChart – Francis module. Software used to Calculate the Hill Chart of the Francis Hydraulic Turbines
The paper presents the Hydro Hill Chart - Francis module application, used to calculate the hill chart of the Pelton, Francis and Kaplan hydraulic turbine models, by processing the data measured on the stand. After de-sc...