Correlation Between Aftereffects for Roughness of Surfaces of Metal Counterface and Carbon-Plastics
Journal Title: Фізика і хімія твердого тіла - Year 2015, Vol 16, Issue 2
Abstract
Regularities of change of isotropic roughness surfaces of steel 45 in friction and wear in a pair with polymer composite has been researched. It has been detected that the topography of the conjugated metal surface with polymer composite is the dominant factor in determining the value of wear of carbon-plastics at both the start and in the process friction and wear when the metal surface roughness is created by the composite. It has been established that between aftereffects values for roughness of metal counterface and polymer composite in friction and wear exists reliable linear relationship.
Authors and Affiliations
H. O. Sirenko, L. M. Soltys, M. B. Skladanyuk
Keywords
Related Articles
- EP ID EP307991
- DOI 10.15330/pcss.16.2.388-397
- Views 42
- Downloads 0
The Transformation of the Structure at Heating and Mechanism of Thermal Expansion of Sn-Bi Eutectic Alloy
The short range order structures of Sn-Bi eutectic melt has been studied by means of X-ray diffraction and reverse Monte-Carlo methods within 420 – 1120 К temperature range. Temperature dependences of interatomic distanc...
The Peculiarities of Structure Formation Upon Sintering of TiH2+TiB2 Powder Blends
The investigation results on peculiarities of phase and structure formation as well as sintering kinetic of compacted TiH2 - TiВ2 powder blends. It was shown, the most intensive shrinkage upon heating took place within t...
The Flow Behavior of Organic Liquids Inside Carbon Nanotubes
Within the methods of electron density functional and ab initio pseudopotential, it were obtained the spatial distributions of density of valence and the total energy for migration of water (or methanol) inside carbon na...
The Time Stability of Changes of the Fundamental Optical Absorption Edge of Amorphous GeSe Films Induced by g-Irradiation
The influence of ((Со60)-radiation at 104–106 Gy doses on the structure and optical properties of amorphous GeSe thin films obtained by the method of flash evaporation on the substrates at Ts = 293 K is being investigate...
Application of Gas Atomised MmNi4,3Al0,2Mn0,5 Alloy as Material of the Negative Electrode in Ni-MH Batteries
The electrochemical properties of the gas atomised MmNi4,3Al0,2Mn0,5 alloy electrodes such as activation rate, discharge capacity and high rate discharge ability have been investigated. Determined using electrochemical i...