Cost Effective Printing of Laboratory Reports: Biochemist’s and Physician’s debate and Institutions Dilemma
Journal Title: Journal of Clinical and Diagnostic Research - Year 2017, Vol 11, Issue 2
Abstract
Introduction: Laboratory investigations account for significant percentage of healthcare expenses. Every hospital and laboratory especially in the government sector wants to cut down the expenses on reports and offer inferior printouts of reports. The debate of printing attractive reports (clientele aspiration) Vs costs cutting (managerial issues) continues. It becomes the moral responsibility of doctors to guide the management into implementing an effective and economical option of report transcription. Cutting cost is always good but it should be achieved in an effective way keeping in mind the expectation of all the stake holders and ensuring that quality is not significantly compromised. The data regarding economics of printing available on the Internet may be market driven and not a true reflection of printing cost. The present study was undertaken to generate data on the economics of printing reports on various platforms to enable managers to make informed decision on choice of optimal printing option. Aim: To provide practical data on economics of printing reports using various printing options available in the country. Materials and Methods: Four printing devices (laser printer, inkjet printer, dotmatrix printer and thermal printer) were connected to the laboratory information system and the reports printed from them were critically evaluated for the following parameters - cost of stationary, printing cost, time of printing and clientele satisfaction. Results: The cost of printing a single report on laser printer, inkjet printer, dotmatrix printer and thermal printers was Rs 0.75, Rs 0.65, Rs 0.20 and Rs 0.93 respectively. The time taken to print 30 reports were 162 sec, 193 sec, 210 and 60 sec respectively. Clientele satisfaction scores were best with Laser and Inkjet printed reports. Conclusion: The most economical mode of printing is Dot Matrix printer using DOS output for printing. However, when the workload of a laboratory is high, then the use of laser printer is not prohibitively expensive option and can be resorted to. Use of thermal printer was found to be unsatisfactory
Authors and Affiliations
arun kumar harith, Anil kumar avs, sangeetha sampath
Utilisation of Adolescent Health Services Under RMNCH+A in an Urban Slum of Berhampur, Odisha, India
ABSTRACT Introduction: Adolescents constitute 22.3% percent of the global population. Many challenges are faced by the adolescent girls for which adolescent health services under National Rural Health Mission (NRHM) are...
A Comparative Study on the Efficacy of i.v. Cyclophosphamide Pulse Versus Oral Cyclophosphamide in Bullous Pemphigoid
ABSTRACT Introduction: Bullous pemphigoid is an acquired autoimmune blistering disorder characterised by subepidermal bullae and deposition of complements and antibodies along the basement membrane zone. It most commonl...
Ectopic Parathyroid Adenoma Presenting as a Mediastinal Mass
A parathyroid adenoma present in an ectopic site, in the anterior mediastinum, is a rare cause of persistent hyperparathyroidism. Though its occurrence in the mediastinum is unusual, existence has been noted in literatur...
Comparison of Posterior Short-segment Pedicle Screw Fixation with or without Fusion in Thoracolumbar Burst Fractures
ABSTRACT Introduction: Treatment of unstable Thoracolumbar vertebra burst fractures has seen a paradigm shift from conservative to surgical modalities with either a short or long-segment posterior fixation with or withou...
Association between Sedentary Behaviour and Depression, Stress and Anxiety among Medical School Students in Chennai, India
ABSTRACT Introduction: Physical inactivity has been found to be a major contributing factor for occurrence of non-communicable diseases like cardio vascular diseases, type 2 diabetes, dyslipidemia and also certain mental...