Design & Analysis of Exhaust Heat Recovery System
Journal Title: GRD Journal for Engineering - Year 2018, Vol 3, Issue 6
Abstract
The exhaust gases from the IC Engine caries away about 30% of heat of combustion. The energy available in the exit stream goes as waste, if not utilized properly. The major technical constraint that prevents implementation of ways to heat recovery system is due to its intermittent and time mismatched demand and availability of energy. In the present work, a storage container is integrated with IC engine setup to extract heat from the exhaust gases using a copper plate being heated by forced convection. The performance parameters pertaining to the heat recovery such as amount of heat covered, temperature achieved at every RPM, velocity of exhaust gases and flow curves will be evaluated, analyzed and reported. The feasibility, advantages and disadvantages of the project have also been discussed
Authors and Affiliations
Hardik Jamwal, Shivam Sharma, Sourab Gupta, Sanjeev Gupta, Siddhant Jandial
Keywords
Related Articles
- EP ID EP293005
- DOI -
- Views 86
- Downloads 0
A Concise Review on Introduction to Hydrological Models
In recent scenario of rapid urbanization and industrialization causes various changes in our natural resources like air, water, soil etc. Various problems are caused due to these changes such as drought, frequent floods,...
Camera Shake Removal using Weighted Fourier Burst Accumulation and NLmeans Denoising
Taking photos under dim lighting conditions using a hand-held camera is very challenging. If the camera is set to a large exposure time, the image is blurred due to camera shake. On the other hand, if it is taken with a...
Improving Raw Milk Quality using Whatsapp – A Rise of Digital India in Indian Dairy Sector
Milk which is considered like nectar in our scriptures is now being adulterated with chemicals, has residues of antibiotics, hormones and pesticides as well as a wide range of microorganisms, including pathogens, in numb...
Study of Tin and Cobalt Oxide Thin Film Prepared by Electrochemical Deposition by Two Electrode Configuration System
Thin film of Tin was prepared by using two electrode configuration electrochemical deposition techniques on stainless steel substrate. The bath for deposition film was aqueous containing 0.1 N SnCl2 (Tin Chloride) as pre...
Structural Behaviour of Concrete with Replacement of Fevicol
The aim of the experiments to increase the strength of the concrete and performance of the concrete. In this experiment the study on strength characteristics of M15 grade concrete using Fevicol as a replacement of cement...