Design and Analysis of Disc Coreless Permanent Magnet Integrated Starter and Generator with Non-uniform Magnetic Pole
Journal Title: 河南科技大学学报（自然科学版） - Year 2018, Vol 39, Issue 4
Abstract
In order to improve the output characteristics and reduce the cost of integrated starter and generator ( ISG) , a non-uniform magnetic pole Halbach disc coreless permanent magnet integrated starter and generator was presented based on Halbach array permanent magnet theory and the three layers winding technology.Firstly, the structure and characteristics of ISG, and the calculation process of the electromagnetic field were analyzed. Secondly, taking the air gap magnetic field distribution as design goal, the three-dimensional finite element analysis software was used to optimize the structural parameters including the permanent magnet pole arc ratio, armature diameter ratio and yoke thickness of rotor. The results show that compared with the forecast structural parameters, the proportion of the primary and secondary magnetic poles of the permanent magnet is5∶ 2∶ 1∶ 2, and the fundamental magnetic density of the air-gap is increased by 9. 72%. Three layers winding is not only increase the effective length of side coil, but also improve the utilization rate of the air gap magnetic field. The overage value of the induced electromotive force is increased by 8%.
Authors and Affiliations
Yubin LI, Zongxiao YANG
Keywords
Related Articles
- EP ID EP468199
- DOI -
- Views 74
- Downloads 0
Microwave Synthesis of K2Ti4O9 Whiskers
The microwave heating was applied to synthesize K2Ti4O9 whiskers by using K2CO3 and TiO2powders as raw materials. The phase composition and microstructure of the samples were characterized by X-ray diffraction( XRD) and...
Effect of Urban Road Slope and Speed on Motor Vehicle Emission
To study the impact of urban road gradient change on motor vehicle emissions, based on vehicle emission test platform, the actual road emission data was obtained. Through the vehicle specific power ( VSP) backstepping, t...
Experiment on Developing Technology with Plastic Tube Cast-in-place Concrete Pile in Construction
Plastic tube cast-in-place concrete pile( TC pile) had obvious reaming effect and pre-bearing capacity shortage in the construction. In view of this issue,developing new technology test for TC pile was carried out. This...
Effect of Processing Parameters on Contact Force with High Speed in Cold Roll-beating Process
1
Effect of Cold Rolling on Interfacial Microstructure and Properties of Ti-Al Roll-casted Composite Plate
The Ti-Al composite plate was prepared by cast-rolling method and cold rolling. Mechanical properties of different deformations of composite plate were detected by universal testing machine. The microhardness near the in...