Design and Implementation of Sensored Brushless DC Motor Control Using dsPIC30F4012 for CW/CCW Bidirectional Rotation
Journal Title: Engineering and Technology Journal - Year 2024, Vol 9, Issue 02
Abstract
This paper presents the development of BLDC (Brushless DC) motor control based on dsPIC30F4012. The system is designed to control motor rotation in clockwise (CW) and counter clockwise (CCW) directions. There are 3 input pins used to facilitate the control interface, namely ground (GND) pin, control (CTRL) pin and enable (EN) pin. An analog input was assigned as command input for rotation in CW/CCW direction. The CTRL pin input has full-scale of analog input that comprises of three regions, namely CCW rotation input (0V~2.4V), CW rotation input (2.6V~5V), and neutral input (2.5±0.1)V as the deadband. The commutation sequences of six steps for direction of motor rotation, while P-I (Proportional-Integral) controller is used to control the motor current. The control law and commutation sequences are implemented in single chip dsPIC30F4012 microcontroller. To verify the system performance, we test the system implementation to drive BLDC motor and measured current are sent to the host PC through serial communication. From the experimental results it is shown that the realizing P-I controller is good performance in small frequency where the bldc motor current can follow the input commands. The bandwidth of motor control to characterize the performance of designed system is also presented.
Authors and Affiliations
Yusie Rizal , Sarifudin,
Keywords
Related Articles
- EP ID EP731429
- DOI 10.47191/etj/v9i02.14
- Views 49
- Downloads 0
ADDITIVE MANUFACTURING COST MINIMIZATION TECHNIQUES: SUCCESSES, CHALLENGES AND FUTURE GROWTH IN SUPPLY CHAIN MANAGEMENT
The competiveness in manufacturing, coupled with the need to reduce cost and manufacture of smaller or fewer, sometimes complex components has accelerated the growth of additive manufacturing in recent years. However,the...
Sonochemical Synthesis of Zinc Oxide Nanoparticles and its Applications
This work is to synthesize Zinc Oxide nanoparticles using ultrasound using Sonication probe with Zinc Acetate as the reagent. These sonochemically synthesized Zinc Oxide nanoparticles are crystalline structure and the mo...
A COMPARATIVE STUDY OF THE BEHAVIOUR OF HYBRID FIBER-REINFORCED CONCRETE (HFRC) BEAMS SUBJECTED TO LOW-VELOCITY IMPACT LOADS UNDER VARIOUS BOUNDARY CONDITIONS
This study investigates the structural behaviour of Hybrid Fiber-Reinforced Concrete (HFRC) beams with the incorporation of steel and polypropylene fibers, considering various boundary conditions under low-velocity impac...
Identifying Carbon Footprint Emitted by Geodetic Engineers in San Ildefonso Bulacan When Conducting Survey Activities
Because of increasing concern about climate change and carbon emissions as a primary contributor, many companies and organizations are pursuing “carbon footprint” projects to estimate their contributions to global climat...
WIRELESS SENSOR NETWORK LOCALIZATION TECHNIQUES PERFORMANCE
A large number of inexpensive, small sensors make up a wireless sensor network. The collection and transmission of data is one of the crucial functions of a sensor network. In the greater part of the applications, it is...