Design of Inset-Fed Triple-Band Rectangular Microstrip Antenna for Wimax, 5.5 Ghz Wlan and Lower X-Band Satellite Applications
Journal Title: International Journal of Electrical and Electronics Engineering Research (IJEEER) - Year 2017, Vol 7, Issue 4
Abstract
In this paper, a novel design of triple-band inset-fed rectangular micro strip antenna with T-shapeslitloade disproposed for WiMAX, 5.5 GHz WLAN and lower X-band satellite applications is presnted. The proposed antenna consists of rectangular radiating elements with a T-shape slot loaded, which is excited through simple 50Ω in set microstrip feed-line. The antenna configuration is printed on a 40 × 30 × 1.6 mm3 low cost FR-4 dielectric material having permittivity of 4.2 which includes ground plane. To obtain a triple-band operation, a narrow Tshaperectangularslitisembeddedat the top non-radiatingedge of the radiating patch. The proposed antennaresonatesat three frequencies of 3.11, 5.5 and 6.30 GHz with -10 dB impedancebandwidths of BW1= 6 % (2.91-3.05 GHz), BW2= 7.27% (5.34-5.69 GHz) and BW3= 4.14% (6.13-6.41GHz). The simulation results are obtained by utilizing 3D full-wave high frequency structural simulator (HFSS) for comparison with experimental results. Acceptable agreement isobserved between the both experimental and simulation results. The obtained results indicatethat, the propose dantenna shows broadside radiation characteristics a tthree operating frequency bands. Owing to its simple antenna structure and its radiation characteristics, it is highly recommendable for applications at which adequately covers the frequency bands of WiMAX, 5.5 GHz WLAN and X-band lower satellite communication (6-6.5 GHz). The details of antenna designing and results are presented and discussed.
Authors and Affiliations
Ashwini C Tengli, P. M. Hadalgi
Keywords
Related Articles
- EP ID EP240281
- DOI -
- Views 121
- Downloads 0
Comparison of Various Types of Illumination Schemes
The reported research elaborates illumination schemes employed in the domestic applications. A unit of energy saved is equivalent to three units of generation, hence it is also important to optimally utilize the availabl...
Low Cost BLDC Drive Using Single Current Sensor
This paper provides a technique to minimize torque ripple in BLDC motor by using single current sensor. There are number of techniques avail to minimize torque ripple. This paper proposes hysteresis current controller. B...
HEALTH STRUCTURE MONITORING AND TRACKING USING WSN
This paper presents the prototype design of an patient’s vital status provided by smart technology. The prototype system collects vital status and sends to medical examiners in emergency or criti...
A1GHz Class E Power Amplifier for Wireless Applications
In this paper, a class E power Amplifier (PA) suitable for wireless applications (Wi-Max, cellular phones, cordless phones etc,) is proposed by using the device of RF3931GaN HEMT (Gallium Nitrate High Electron Mobility T...
Automatic Solar Photovoltaic Battery Monitoring and Theft Control system
Being able to monitor the SPV battery remotely then it makes important to reducing time and cost associated with site visits. This is obviously especially important for an-off-grid system, which is often in even harder t...