Design Techniques For Low Power Implicit Pulse Triggered Circuits
Journal Title: International Journal for Research in Applied Science and Engineering Technology (IJRASET) - Year 2015, Vol 3, Issue 12
Abstract
In Integrated circuits, the portion of the on chip power is covered by clock distribution network, flip-flops and latches. Flip flops and latches absorb large amount of power due to redundant transitions and clocking system. In this paper low power flip-flops are presented. The single edge triggered conditional data mapping flip-flop(CDMFF) and clocked pair shared flipflop(CPSFF) are explained and compared with proposed flip-flop. The proposed flip-flop uses the double edge triggering technique by reducing the frequency to half. These flip-flops are simulated in HSPICE of 0.18μm CMOS technology with a power supply of 1.8V and a frequency of 50MHZ.
Authors and Affiliations
Smt. A. Rajani, A. Yamini
Keywords
Related Articles
- EP ID EP21455
- DOI -
- Views 243
- Downloads 5
Analysis of Water Transmission Behaviour in Sandy Loam Soil under Different Tillage Operations of Mould Board Plough applying /Using Different Infiltration Models
The present research work was performed to investigate the effect of tillage intensity to the water transmission behavior for sandy loam soil in terms of infiltration rates and cumulative infiltration and its validation...
A Review on Coir Fiber Treated with natural rubber Latex as Concrete Reinforcement Material in cement Based Composites
Concrete is acknowledged to be a relatively brittle material and when subjected to normal stresses and impact loads, the tensile strength is one tenth of its compressive strength. Because of this characteristics, concre...
An Analytical Survey of Privacy Preserving Schemes in Cloud Computing
Cloud computing has been considered as the next generation information technology architecture. It provides the potential to eradicate the requirements to set up the high cost computing infrastructure for IT –based serv...
Autonomous Robot for Identification of Soil Parameters and Collecting Scrap from Farm
According to UNICEF solid waste can be classified into biodegradable and non biodegradable. Non biodegradable wastes cannot be decomposed by biological process. Plastics and other metals in agricultural field cause many...
Development Of An Optimized Hybrid System Based On PV And Biomass
enewable energy can be seen as one of the important prospect of today’s research, as it enlightens the lives of millions of people by fulfilling multiple necessities of their daily life and simultaneously overcomes the...