DETERMINATION OF INSULATION PARAMETERS OF CURRENT TRANSFORMERS AT MULTIPLE MEASUREMENTS IN MONITORING SYSTEMS UNDER WORKING VOLTAGE
Journal Title: Електротехніка і Електромеханіка - Year 2016, Vol 0, Issue 5
Abstract
Features of the data processing procedures of multiple measurements of the dielectric loss tangent of the high-voltage insulation, which are based on the comparison method, were considered. Three procedures were compared: the one procedure uses an assignment of a particular standard object for comparison, and two procedures don't use assignments of the special standard objects. Expressions of methodical errors of studied procedures were obtained. Analysis and calculations, which use the obtained expressions were made. Evaluations showed that an influence of a change of the tangent of dielectric loss of one from the monitoring objects on results of estimation of the tangents of other monitoring objects is the distinctive feature of the procedures without assignment of the standard object. Errors of these procedures more than errors of the traditional procedure, with assignment of the standard object. The study demonstrated that procedures without assignment of standard objects lead to difficultly predictable methodological errors, which hinder to estimate the actual value of the loss tangent and to estimate outcomes of the monitoring, by means comparing with allowable values. Moreover, the decrease of estimations of loss tangents of all objects, as a result of occurrence of at least one the object with strongly bad parameters, hides occurrence of other unsuccessful objects with smaller deviations and makes difficult recognition of such deviations at early stages. Improvements in processing techniques which reduce earlier specified errors and reduce the amount of measurements are proposed. The study results are useful in monitoring and diagnostic of basic insulation of current transformers or high-voltage bushings.
Authors and Affiliations
V. K. Beliaev, H. N. Panenko
Keywords
Related Articles
- EP ID EP297721
- DOI 10.20998/2074-272X.2016.5.06
- Views 108
- Downloads 0
SYNTHESIS OF NEURAL NETWORK MODEL REFERENCE CONTROLLER FOR AIMING AND STABILIZING SYSTEM
The aim of this work is the synthesis of neural network reference model controller. The synthesis is performed in MATLAB for the problem of control of the aiming and stabilization system for the special equipment of movi...
ANALYSIS OF THERMAL STATE OF TRACTION BRUSHLESS PERMANENT MOTOR FOR MINE ELECTRIC LOCOMOTIVE
Purpose. The study was conducted to analyze thermal state of the traction permanent magnet synchronous motor for mine electric battery locomotive when operating in continuous and short-time duty modes. These operating mo...
CLASS STRUCTURE OF ELECTROMECHANICAL ENERGY CONVERTER MODELS WITH UML-DIAGRAMS APPLICATION
Theoretical results are presented, mathematical model formation by means of inheritance from a generalized class template is shown for a general electromechanical energy converter.
MASS AND COST FIGURES FOR SPATIAL AXIAL THREE-PHASE ELECTROMAGNETIC SYSTEMS WITH CIRCULAR AND HEXAGONAL FORMING CONTOURS OF TWISTED MAGNETIC CORE RODS
For a spatial three-phase axial electromagnetic system with double-contour phase elements of the twisted butt-end magnetic core, analytical dependences for optimal geometrical relations determination over minimum active...
EFFECT OF THE THICKNESS OF INSULATION OF PROTECTED WIRES OF HIGH-VOLTAGE OVERHEAD TRANSMISSION LINES TO THEIR CURRENT CARRYING CAPACITY
Introduction. The main direction of technical policy in the design, construction and technical re-equipment of transmission lines is the modernization of electrical networks and increase their energy efficiency in order...