Development of a Constitutive Friction Law based on the Frictional Interaction of Rough Surfaces
Journal Title: Tribology in Industry - Year 2015, Vol 37, Issue 4
Abstract
Friction has a considerable impact in metal forming. This is in particular true for sheet-bulk metal-forming (SBMF) in which local highly varying contact loads occur. A constitutive friction law suited to the needs of SBMF is necessary, if numerical investigations in SBMF are performed. The identification of the friction due to adhesion and ploughing is carried out with an elasto-plastic half-space model. The normal contact is verified for a broad range of normal loads. In addition, the model is used for the characterization of the occurring shear stress. Ploughing is determined by the work which is necessary to plastically deform the surface asperities of the new area that gets into contact during sliding. Furthermore, the surface patches of common half-space models are aligned orthogonally to the direction in which the surfaces approach when normal contact occurs. For a better reflection of the original surfaces, the element patches become inclined. This leads to a geometric share of lateral forces which also contribute to friction. Based on these effects, a friction law is derived which is able to predict the contact conditions especially for SBMF.
Authors and Affiliations
F. Beyer , F. Hauer , K. Willner
Keywords
Related Articles
- EP ID EP143554
- DOI -
- Views 84
- Downloads 0
Study of Surface Wear and Damage Induced by Dry Sliding of Tempered AISI 4140 Steel against Hardened AISI 1055 Steel
In industry, the sliding mechanical systems are subject to friction and wear phenomena. These phenomena can be the origin of a reduction of the efficiency of the mechanical system even to be responsible for its incapacit...
Cassava Leaf Nanoparticles (CLNPs) as a Potential Additive to Anti-Corrosion Coatings for Oil and Gas Pipeline
Characterization of synthesized cassava leaf nanoparticles (CLNPs) was carried out using SEM/EDX and Gwyddion software, XRD and TEM for cassava leaves (CL) ball milled at 36, 48, 60 and 72 hours. The morphological study...
Suitability of Recycled Polyethylene/Palm Kernel Shell-Iron Filings Composite for Automobile Application
A recycling aimed research was carried out to produce a new composite material and proffer suggestion for the possible use of the newly developed composite material. The empty water sachet (commonly called pure water nyl...
Investigations into the Degradation of PTFE Surface Properties by Accelerated Aging Tests
This paper describes an accelerate aging procedure used for investigating the surface alteration of PTFE gaskets commercialized by two alternative producers. These gaskets are installed in modern process plants where tir...
Effect of TiO2 Nanoparticles Blended with Lubricating Oil on the Tribological Performance of the Journal Bearing
This paper presents the performance analysis for plain and elliptical journal bearing operating with industrial lubricants. Titanium dioxide nanoparticle of size 40 nm is used as a lubricant additive to examine the perfo...