Development of Nationwide Vs30 Map and Calibrated Conversion Table for Indonesia using Automated Topographical Classification

Journal Title: Journal of Engineering and Technological Sciences - Year 2017, Vol 49, Issue 4

Abstract

A nationwide Vs30 map for Indonesia was developed based on automated topographic classification from 90-m grid digital elevation data and their correlation with Vs30. Automated topographic classification has been proposed by Iwahashi and Pike (2007) and a procedure to convert topographic class into Vs30 maps has been developed by Imamura and Furuta (2015) based on Vs data from J-SHIS (Japan Seismic Hazard Information System). In order to be suitable for Indonesia, calibration work according to Imamura and Furuta’s procedure should be conducted since the geotechnical conditions in Japan may not be the same as in Indonesia. This paper presents adjustment of the Vs30 correlation by Imamura and Furuta to convert topographic class into Vs30 and construct a Vs30 map of Indonesia. This correlation was calibrated by using Vs data from BMKG (Indonesian Agency for Meteorological, Climatological, and Geophysics) as well as standard penetration test logs that were collected by the authors. Utilization of local field measurement data will certainly enhance the reliability of the Vs30 map. The developed nationwide Vs30 map will be very useful for disaster mitigation programs and for preliminary design of earthquake resistant buildings and infrastructure in Indonesia.

Authors and Affiliations

Masyhur Irsyam

Keywords

Related Articles

Pervaporation of Acetic Acid-Water Mixture Using Silica Membrane Prepared by Sol-Gel Method

Silica membranes were developed and tested for the separation of acetic acid and water by pervaporation. Thin microporous silica membranes were prepared on a porous alumina tube by sol-gel method using tetraethyl orthosi...

Behavior of Sandwich Tubular-hat Sections with Aluminum Foam Filler Subjected to Low Velocity Impact Load

In this paper, a comprehensive literature review is presented regarding dynamic progressive buckling analyses of foam-filled hat section columns. The results obtained from a numerical simulation were in good agreement wi...

Study of Hall Effect Sensor and Variety of Temperature Related Sensitivity

Hall effect sensors are used in many applications because they are based on an ideal magnetic field sensing technology. The most important factor that determines their sensitivity is the material of which the sensor is m...

Anatomy of Injury Severity and Fatality in Indonesian Traffic Accidents

There has been a steady increase in traffic accidents with major injuries in Indonesia over the last 10 years, especially those with a score higher than 3 on the Abbreviated Injury Scale (AIS). Frontal, side, and rear co...

Supply and Demand Analysis of Water Resources based on System Dynamics Model

Humans require clean water for industrial, agricultural, domestic and ecological purposes. Due to climate change and population increase, the lack of clean water resources is becoming more and more serious. A system dyna...

Download PDF file
  • EP ID EP324058
  • DOI 10.5614/j.eng.technol.sci.2017.49.4.3
  • Views 95
  • Downloads 0

How To Cite

Masyhur Irsyam (2017). Development of Nationwide Vs30 Map and Calibrated Conversion Table for Indonesia using Automated Topographical Classification. Journal of Engineering and Technological Sciences, 49(4), 457-471. https://europub.co.uk./articles/-A-324058