DEVELOPMENT TRENDS AND IMPROVEMENT WAYS OF A WIND TURBINE SIMULATION SYSTEMS
Journal Title: Електромеханічні і енергозберігаючі системи - Year 2017, Vol 3, Issue 39
Abstract
Purpose. To systematize the approaches to synthesis of wind turbine simulators and to develop the recommendations for the improvement of these systems. Methodology. Based on a comprehensive literature review, the generalized structure of a wind turbine simulation system is presented. The principle of work of wind turbine simulators is described. Designing features of an electromechanical system and a software-control system are analyzed. Results. Trends of designing of a wind turbine simulators are presented and improvement ways for these systems are developed. In most wind turbine simulators are constructed on the basis of torque controlled direct current or alternating current electric drive with simplified generating system of wind power plants as a load. Usually separately excited direct current motor driven by a controlled rectifier, or induction motor driven by a frequency converter can be used to reproduce the static and dynamic characteristics of real wind turbines. Wind turbines mathematical models usually takes into consideration dynamic effects of wind turbine like inertia effect, tower shadow effect, gradient effect, gearbox inertia and shaft elasticity to varying degrees without analysis of influence on simulation quality. The power-speed pattern of the wind can be generated from the data based on the Van der Hoven power spectrum or Weibull distribution, from the actual recorded wind speed data or from manual set up. Originality. The complex analysis of the features of the structural synthesis of wind turbine simulation systems is carried out and recommendations for improving the construction and effectiveness of use of wind turbine simulators are developed. Practical value. The obtained results allow to optimize the process of designing wind turbine simulators.
Authors and Affiliations
Oleksii Burov, Nataliia Vlasiuk
Keywords
Related Articles
- EP ID EP660462
- DOI -
- Views 153
- Downloads 0
IDENTIFICATION OF NONLINEAR PARAMETERS OF ROTOR’S IN THE EQUIVALENT CIRCUIT OF INDUCTION MOTOR WITH USE OF ENERGY STORAGES
Purpose. Substantiation of the possibility of identification of nonlinear parameters of the equivalent circuit of induction motor using energy storage devices. Methodology. The article proposes an approach to determining...
ENERGY-SAVING CONTROL OF A TRACTION FREQUENCY-REGULATED SYN-CHRONOUS RELUCTANCE MOTOR
Purpose. The article is devoted to the study of energy and electromechanical processes, the development of energy-saving control for a traction frequency-controlled synchronous reluctance motor in steady-state regimes a...
MATHEMATICAL MODEL OF THE ELECTRICAL SUPPLY SYSTEM OF THE ADMINISTRATIVE BUILDING WITH A KINETIC ENERGY STORAGE DEVICE
Purpose. The purpose of this article is to develop a mathematical model of the power supply system of an administrative building with the use of a kinetic energy storage under the condition of a random load of the consum...
MODES FEATURES OF INTEGRATED ENERGY SUPPLY SYSTEMS OPERATION
Purpose. To investigate and monitor the state of the integrated energy systems with energy hubs and distributed generation sources one must formalize the main operation modes of the mentioned systems. These modes may be...
DETERMINATION OF STATOR RESISTANCE OF INDUCTION MOTORS ON STARTING CHARACTERISTICS
Purpose. Determination of a torque of the asynchronous engine is important for increase in indices of use of the electric power. This task can be solved on condition of reliable identification of value of the active resi...