DIELECTRIC SPECTROSCOPY OF CASING THERMOSETTING COMPOSITE ELECTRICAL INSULATION SYSTEM OF INDUCTION TRACTION ELECTRIC MACHINES
Journal Title: Електротехніка і Електромеханіка - Year 2018, Vol 0, Issue 1
Abstract
Introduction. Thermosetting composite electric insulation of traction electric motors undergoes significant heating, moisture, overvoltage, vibration. Purpose. The substantiation of the possibility of using dielectric spectroscopy for monitoring the state of the hull thermosetting composite electric insulating system of induction traction motors (ITM) at the technological stage of manufacturing.. Methodology. In the induction traction motors in which the phases of the stator winding are connected to a «star» and do not have a zero point output, in the case of a two-electrode connection of one of the phases and the housing, the combined characteristics of the capacitance and the dielectric loss tangent of the three-phase hull insulation system are measured. Practical value. It is established that at the second resonant frequency near 10 kHz, the tangent of the dielectric loss is the most sensitive to the state of the composite ITM insulation. Dielectric spectroscopy at alternating voltage of the combined dielectric characteristics makes it possible to evaluate the state of the hull thermosetting electrical insulating system at the final stage of manufacturing of induction traction motors.
Authors and Affiliations
G. V. Bezprozvannych, A. V. Roginskiy
Keywords
Related Articles
- EP ID EP483734
- DOI 10.20998/2074-272X.2018.1.02
- Views 98
- Downloads 0
RESEARCH OF DYNAMIC PARAMETERS OF THE ELECTRIC DRIVE ON THE BASIS OF ROLLING ROTOR MOTOR
Purpose. Development and investigation of a dynamic model of electric drive on the base of the rolling rotor motor (RRM) which reflects the positioning of the actuator of the locking and regulating equipment in time. Met...
THE STABILITY MONITORING OF THE MANUFACTURING PROCESS OF ELECTRICAL INSULATING SYSTEMS OF TRACTION ELECTRIC MACHINES
Introduction. Electrical insulation systems make up about 0.03 % of the traction electric machines (TEM) mass, but they are of exceptional importance and affect the design capabilities and manufacturing techniques of ele...
DETERMINATION OF ANALYTICAL CALCULATION ERROR OF MAGNETIC FIELD OF HIGH-VOLTAGE CABLE LINES WITH TWO-POINT BONDED CABLE SHIELDS CAUSED BY NON-UNIFORM CURRENT DISTRIBUTION IN THE SHIELDS
This paper deals with the determination of analytical calculation error of magnetic field of high-voltage cable lines in two-point bonded cable shields caused by non-uniformity of the current distribution in the shields....
A REVERSE MODE OF THREE-PHASE ASYNCHRONOUS MOTORS WITH HEXAPHASE WINDINGS
A reverse operation feasibility in three-phase asynchronous motors with the stator hexaphase windings is proved. In the reverse mode, the hexaphase windings are shown to keep all their declared advantages.
ON THE PROBLEM OF INCREASING COMPUTATION ACCURACY FOR RATED PARAMETERS OF ACTIVE ELECTRICAL INSTALLATION GROUND GRIDS
In the paper, factors having effect on computation accuracy of ground grid rated parameters are analyzed. Directions and techniques for increasing the rated parameter computation accuracy are suggested. The techniques co...