DISTRIBUTION OF STRESSES/STRAINS IN CAST IRON–COMPOSITE CONTACT IN LUBRICATED CONDITIONS BY MEANS OF FEM
Journal Title: Scientific Journals of Silesian University of Technology. Series Transport - Year 2012, Vol 2012, Issue 74
Abstract
In this paper presented model occurring in piston ring – cylinder linear and piston – cylinder liner. The materials in these contacts were made from composites and casts iron. The real shape and size of reinforcement phases (Al2O3) in composite were determined on the basis of metallographic and statistic examination. On the basis of these examination could be reconstruction the real shape of reinforcement phase hard particles. The main aims of the simulation research were determination of stresses and strains in extreme service condition.
Authors and Affiliations
Henryk BĄKOWSKI
Keywords
Related Articles
- EP ID EP114268
- DOI -
- Views 45
- Downloads 0
Analysis of road traffic safety in Silesian province on the background of Poland
Silesia province is a one of the most urbanized part of the Poland. The high rate of motorization is a challenge for a dense network of roads and streets in this area. The statistics on the road traffic accidents and the...
PLASTICITY OF SELECTED METALLIC MATERIALS IN DYNAMIC DEFORMATION CONDITIONS
Characteristics of a modernized flywheel machine has been presented in the paper. The laboratory stand enables to perform dynamic tensile tests and impact bending with a linear velocity of the enforcing element in the ra...
HOW TO WRITE RIGHT PROJECT IN THE NEW BUDGET OF THE EC IN 2014-2020 YEAR FOR SMALL AND MEDIUM ENTERPRISES
Real barrier in development of enterprise can be technology absorption barrier, that means non suitable potential, that make un possible effective adaptation right technical solution from market, are higher in the caus...
VOYAGE PLANNING
A sea voyage can be divided into three parts with varying degrees of risk: - from the berth at the port of departure to the pilot disembarkation point - from the pilot disembarkation to another pilot embarkation point...
MODELOWANIE USZKODZEŃ ŁOŻYSK TOCZNYCH PRZEKŁADNI ZĘBATYCH STANOWISKA MOCY KRĄŻĄCEJ
Artykuł zawiera opis metody modelowania uszkodzeń łożysk tocznych zastosowanej w modelu stanowiska przekładni zębatych pracujących w układzie mocy krążącej (FZG). Uwzględnienie w modelu wpływu uszkodzeń wybranych element...