Dynamic Analysis of Thin Plates with Defects by Experimental and FEM Methods
Journal Title: Romanian Journal of Acoustics and Vibration - Year 2013, Vol 10, Issue 2
Abstract
In this paper an analysis regarding the dynamics of thin rectangular plates embedded on all edges is presented; aiming to highlight the effect of defects upon their natural frequencies. The first thirty natural frequencies were obtained for a plate without defect and the same plate with four different types of defect. It was placed in the corner of the plate; one dimension (the length of defect) was increased successively. The results in terms of frequencies and mode shapes are finally presented from all values obtained in tabular form, were prepared graphs to compare the results and highlighting the way how natural frequencies changes due to defect. Finally, the results are compared with measurements, in order to demonstrate the validity of the theoretical considerations.
Authors and Affiliations
Marius TUFOI, Cornel HATIEGAN, Ovidiu VASILE, Gilbert GILLICH
Keywords
Related Articles
- EP ID EP152007
- DOI -
- Views 67
- Downloads 0
Natural Frequencies of Damaged Beams - A New Approach
This paper introduces a relation which describes the influence of discontinuities on the dynamic response of prismatic cantilever beams. The relation, providing the natural frequencies of weakaxis bending vibration modes...
Rheological Models of the Materials for the Road System in the Compaction Process
This paper presents a simplified theory of compaction based on idealized rheological models that allow to make preliminary determinations of characteristic parameters which in turn are used to determine other parameters[...
Acoustical Silencers (Mufflers)
This paper concerns acoustical silencers mounted on the pipe lines used for the evacuation in the atmosphere of the gas from noise producing equipment: engines, turbines, tanks, air-conditioning and ventilation equipment...
Experimental Investigation of Behavior of Fine Particles in Acoustic Air Flow
This paper deals with the influence of acoustic field on agglomeration of quartz sand particles in the air flow. It is established that particle concentration in polluted air flow decreases in presence of acoustic field....
Industrial Noise Mapping – Support of an Anti-Noise Protection Program
The paper shows an approach to noise problems for an installation belonging to a complex industrial plant, containing noise sources located at different heights. A proper digital modeling of the relevant elements in term...