Effect Of Thermal Load On Valve By Using Conventional Diesel And Blended Fuels
Journal Title: International Journal of Science Engineering and Advance Technology - Year 2015, Vol 3, Issue 11
Abstract
The valves used in the IC engines are of three types: Poppet or mushroom valve or Sleeve valve or Rotary valve. Of these three types, Poppet valve is most commonly used. Since both the inlet and exhaust valves are subjected to high temperatures of 500°C to 1200°C during the power stroke, therefore, it is necessary that the materials of the valves should withstand these temperatures. The temperature at the inlet valve is less compared to exhaust valve. Thus the inlet valve is generally made of nickel chromium alloy steel and exhaust valve is made of si-chrome steel.Automobile engines are usually petrol, diesel or gasoline engines. Petrol engines are Spark Ignition engines and diesel engines are Compression Ignition engines. Blended fuels are mixtures of traditional and alternative fuels in varying percentages. Here the effect of diesel blended fuels on valve is studied by mathematical correlations applying thermal loads produced during combustion. Blended fuels are usually bio fuels blended in different percentages. Percentages vary from 0%, 5%, 10% and 20%.Internal combustion engines produce exhaust gases at extremely high temperatures and pressures. As these hot gases pass through the exhaust valve, temperatures of the valve, valve seat, and stem increase. To avoid any damage to the exhaust valve assembly, heat is transferred from the exhaust valve through different parts, especially the valve seat insert during the opening and closing cycle as they come into contact with each other. In this thesis, a finite-element method is used for modeling the thermal analysis of an exhaust valve. The temperature distribution and resultant thermal fluxes are evaluated. Detailed analyses are performed to estimate the boundary conditions of an internal combustion engine. In this thesis, Catia is employed for modeling and Ansys is used for analysis of the exhaust valve.
Authors and Affiliations
Raja Nayudu| M. Tech. Student, Dept Of ME, KITS , DIVILI, Kuppili. Mohan Krishna| Assistant.Professor Dept Of ME, KITS , DIVILI, V. V. Ramakrishna| Assistant.Professor Dept Of ME, KITS , DIVILI, J. Hari Narayana Rao| Reserch Scholar
Keywords
Related Articles
- EP ID EP16658
- DOI -
- Views 286
- Downloads 7
Solar PV and Battery Storage Integration System Using Three Level NPC Inverter
In this work, another setup of a three-level neutral pointclipped (NPC) inverter that can incorporate sun powered photovoltaic (PV) with battery stockpiling in a lattice associated framework is proposed. The quality of...
Radiaton Pattern Reconfiguration Using Parasitic Elements
A parasitic surface based reconfiguration technique for microstrip antenna beam steering has been presented and discussed in this paper. This concept can be used in reconfigurable antennas without additional modifica...
An Improved Performance Of Pid And Fuzzy Controller Based Sapf For Wind And Solar Power Generation
Amid the previous existences a while, fuzzy controller depends on fuzzy logic included manages in a sure level of ideas can't be communicated as the " genuine" or "false" however a bit "in part genuine" are most dyna...
A Control Scheme for a 3 –Phase Power Converter With An Unbalanced AC Source
Three-stage dc–ac control converters experience the ill effects of power oscillation and over current issues in the event of the uneven air conditioning source voltage that can be caused by lattice/generator shortco...
A New Controlling Technique for Elimination Lower Order Harmonics In A Three Phase PV Inverter System
In this paper, a new controlling technique for elimination lower order harmonics in a three phase PV inverter system topology consisting of a boost section, a low-voltage three-phase inverter with an inductive filter,...