Effects of high-speed cooling on physical and mechanical properties of AMg6 aluminum alloy after high-temperature heating
Journal Title: Технічна механіка, Техническая механика, Technical Mechanics - Year 2016, Vol 2, Issue 2
Abstract
The effects of high-speed cooling on the physical and mechanical properties of the AMg6 aluminum alloy after high-temperature heating have been examined. An experimental procedure for improving the material viscosity in saving the strength characteristics due to a uniform dispersion distribution of the second phase in the grain has been developed. A preliminary heat treatment of the specimens has been conducted using four schemes: heating the specimen to 350 ºC into a furnace, water cooling to the indoor temperature; heating the specimen to 450 ºC in a furnace, water cooling to the indoor temperature; heating the specimen to 350 ºC in a furnace, cooling to -56ºC; heating the specimen to 450 ºC in a furnace, cooling to -56 ºC. High-speed cooling has been conducted in the solution of solid carbon dioxide in alcohol. Tension tests have been carried out using specimens of 50 and 100 mm length made from GOST 1497-84. Impact tests have been conducted using GOST 9454-78. According to the results of the tension experiments the yield point, the material ultimate strength and a relative extension of the specimen have been measured. In the impacts tests the impact strength coefficient and a specific work of failure have been measured. Experimental investigations demonstrated that all of the types of heat treatment reduce the yield point to 16- 20%, increase a specific work of failure to 23% and in practice do not change the yield point and a relative extension of the specimen. Better results on a specific work of failure have been obtained for the scheme of treatment when heating the specimen was performed to the temperature of 450 ºC followed by cooling to -56 ºC.
Authors and Affiliations
A. Kuzmitskaya, V. Zhdanov
Keywords
Related Articles
- EP ID EP352525
- DOI -
- Views 105
- Downloads 0
Increase in target-oriented efficiency of space medium-sized rocket: advanced lines for updating
Advanced lines for updating the space medium-sized carrier rockets (SMSCR) are offered increasing their target-oriented efficiency in an extended operational range. To attain this, untapped internal reserves are consid-e...
Entropy models of self-recovery systems
Complex open systems exposed to various external and internal factors are considered. The possibility of applying the entropy approaches to the development of the mathematical models describing the generalized state of t...
Two-probe implementation of microwave interferometry for motion sensing and complex reflection coefficient measurement
This paper presents the results of the investigations into microwave probe measurements conducted at the Department for Functional Elements of Control Systems of the Institute of Technical Mechanics of the National Acade...
On the adaptation of bifunctional systems of liquid-propellant rocket thrust vector control to modern methods and systems of space rocket stage flight control
The aim of this paper is to demonstrate that bifunctional rocket trust vector control systems can easily be adapted to modern flight control systems of space rocket stages with mass asymmetry that changes during the flig...
Analysis of vertical components of disturbances for conventional predicting dynamic qualities of freight cars
The work aim is to assess the admissibility of a number of components of the calculated disturbances to predict the dynamic qualities of the freight cars in a vertical plane. In the research methods of mathematical model...