Effects of the grid disturbances on Current Source Rectifier controlled by FCS-MPC algorithm
Journal Title: Power Electronics and Drives - Year 2018, Vol 2018, Issue 1
Abstract
Nowadays, the increasing number of nonlinear loads influence the grid causing grid voltage disturbances. Those disturbances may be very dangerous for the equipment and can create faults in converters behavior. However, the right control algorithm can improve the reliability of the work. For Current Source Rectifier the finite control set model predictive control has been proposed. This method is very flexible because of the variety of the possible cost function forms. It has been examined under grid voltage disturbed by the higher harmonics and the voltage drop. Simulation results prove the ability to damp the distortions and to ensure the unity power factor. Summing up, the algorithm is a very good solution in use in applications such as: battery charging, active power filtering, low voltage DC loads feeding.
Authors and Affiliations
Agata Godlewska
Keywords
Related Articles
- EP ID EP408035
- DOI 10.2478/pead-2018-0019
- Views 89
- Downloads 0
Introduction to the Special Section on State and Parameter Estimation Methods for Sensorless Drives
This short article constitutes an introductory part the Special Section on State and Parameter Estimation Methods in Sensorless Drives. In the current issue of the journal the first part of this Section is published. Acc...
AN ARTIFICIAL NEURAL NETWORKS APPROACH TO STATOR CURRENT SENSOR FAULTS DETECTION FOR DTC-SVM STRUCTURE
Background: During last few years, fault-tolerant control systems (FTCS) [1] for electric motor drives became a very active research field for many research groups. The proper choice of the fault tolerant control algorit...
Finite set model predictive speed control of induction motor with long horizon
Background: The paper presents predictive speed control of induction motor. Material and methods: The structure with finite control set and long prediction horizon was used. The control process is divided into two parts:...
PARAMETRIC ANALYSIS FOR THE DESIGN OF A 4 POLE RADIAL PERMANENT MAGNET GENERATOR FOR SMALL WIND TURBINES
Background: A review of the literature gives some guidelines for the design of a Permanent Magnet Synchronous Generator (PMSG). Material and methods: In this work a deeper analysis of the available topologies applied to...
STATOR WINDING INTER-TURN SHORT-CIRCUIT MODELLING OF A SQUIRREL-CAGE INDUCTION MOTOR
Background: A mathematical model of a squirrel-cage induction motor with inter-turn short-circuits in stator phases is presented in this paper. Material and methods: In the proposed mathematical model an extent and angul...