Effects of Ti/Mg molar ratio on bi-supported SiO2/MgCl2 (ethoxide type)/TiCl4 catalysts in ethylene homopolymerization and ethylene/1-hexene copolymerization
Journal Title: Polyolefins Journal - Year 2018, Vol 5, Issue 1
Abstract
SiO2/MgCl2 (ethoxide type)/TiCl4 Ziegler-Natta catalysts for use in ethylene polymerization and ethylene/1-hexene copolymerization have been prepared using silica with a supported layer of magnesium ethoxide (Mg(OEt)2) as a catalyst precursor, followed by treating with TiCl4 at different Ti/Mg molar ratios, which showed significant effects on the active centers and pore structures of the catalysts. The formation amount of β-MgCl2 carrier increased to a maximum with increasing the Ti/Mg molar ratio from 1.50 to 2.25, and then decreased with the further increasing of Ti/Mg molar to 2.50. When the Ti/Mg molar ratio reached 2.25, the catalyst showed the best performance of polymerization, which could be attributed to the most active centers, high surface area and loose surface structure, mainly owing to the high conversion of Mg(OEt)2 to β-MgCl2. The polymers obtained showed medium and high molecular weight (Mw) with medium molecular weight distribution (MWD). In contrast to the conventional Mg(OEt)2-based ZN catalysts, the sphericity of particles was easy to control in this bi-supported catalyst. Furthermore, the prepared catalysts exhibited rather high activity, good copolymerization ability and hydrogen response.
Authors and Affiliations
Liang Zhu, Xuelian He, Ruihua Cheng, Ning ZHAO, Boping Liu
Keywords
Related Articles
- EP ID EP283205
- DOI 10.22063/POJ.2017.1470
- Views 98
- Downloads 0
Study of Ziegler-Natta/(2-PhInd)2ZrCl2 hybrid catalysts performance in slurry propylene polymerization
Several types of hybrid catalysts are made through mixing of 4th generation Ziegler-Natta (ZN) and (2-PhInd)2ZrCl2 metallocene catalysts using triethylaluminum (TEA) as coupling agent. Response surface methodology (RSM)...
Effects of FeCl3 doping on the performance of MgCl2/TiCl4/DNPB catalyst in 1-hexene polymerization
The aim of this study was to examine the effect of catalyst doping on the performance of MgCl2. EtOH/TiCl4 catalyst system. In this regard, a series of undoped as well as FeCl3-doped catalysts was prepared and employed i...
Synthesis of high molecular weight polyethylene using FI catalyst
A FI Zr-based catalyst of bis[N-(3,5-dicumylsalicylidene)-2′,6′diisopropylanilinato]zirconium(IV) dichloride was prepared and used for polymerization of ethylene. The effects of reaction conditions on the polymerization...
Thermal-insulation performance of low density polyethylene (LDPE) foams: Comparison between two radiation thermal conductivity models
The loss of energy, especially in industrial and residential buildings is one of the main reasons of increased energy consumption. Improving the thermal insulation properties of materials is a fundamental method for redu...
Hydrophilic polypropylene microporous membrane for using in a membrane bioreactor system and optimization of preparation conditions by response surface methodology
In this study, the response surface methodology (RSM) based on the central composite design (CCD) was used to optimize the preparation condition of polypropylene-grafted maleic anhydride (PP-g-MA) microporous membrane by...