Eigenmodes analysis of sectoral coaxial ridged waveguides by transverse field-matching technique. Part 1. Theory
Journal Title: Вісник НТУУ КПІ. Серія Радіотехніка, Радіоапаратобудування - Year 2013, Vol 0, Issue 54
Abstract
Introduction. The utilization of ridged structures in modern waveguide devises is discussed. The goals of the research presented in the paper are defined. TE modes. The geometrical configurations of sectoral coaxial ridged waveguides are shown. The formulas obtained in the section allow to compute cutoff wave numbers and electric and magnetic fields distributions of TE modes in the presence of the ridge either on the inner or the outer wall of the waveguide. TM modes. The formulas obtained in the section allow to compute cutoff wave numbers and electric and magnetic fields distributions of TM modes in the presence of the ridge either on the inner or the outer wall of the waveguide. Solutions convergence for cutoff wave numbers. The cutoff wave numbers convergence analysis depending on the amount of partial modes has been carried out. Residual errors plots for cutoff wave numbers computing of first four modes as dependences on the amount of partial modes are presented. It has been shown that it is enough to use 24 partial modes for the calculation of sectoral coaxial ridged waveguides cutoff wave numbers for both configurations by transverse field-matching technique with residual error less than 0.1%. Conclusions. General conclusions of the paper are given.
Authors and Affiliations
S. Piltyay, F. Dubrovka
Keywords
Related Articles
- EP ID EP309033
- DOI 10.20535/RADAP.2013.54.13-23
- Views 92
- Downloads 0
The use of optimal spatial filtering by the method of common spatial pattern for the classification of EEG signals according to the type of brain activity
During EEG due to the volume conduction the signal from each individual source appears simultaneously in a number of channels registered from different leads. Therefore, the recorded EEG signal gives a blurred picture of...
Two-part electrodes of the physical phantom for EIT
In this article explored methods for increasing of the accuracy of measurement in the hardware part of the electrical impedance tomograph, in particular, in its electrode system, which contains two-parts (combined) elect...
Use direct volume magnetostatic waves for convolver construction
It is shown that the use of direct volume magnetostatic waves (FVMSW) in epitaxial ferrite film can be the basis for convolver construction. A theoretical analysis confirmed that the output signal corresponds to the doub...
Coupling coefficients of the disk dielectric microresonators with whispering gallery modes
Calculation results of the Disk dielectric microresonators coupling coefficients are presented. Microresonator coupling coefficients as a functions of main parameters is considered. S-matrix frequency dependences of both...
Spectrum of discrete frequency sequence "Welch-10" and "Welch-16"
Amplitude, phase and energy spectrum of a discrete frequency signal in which the number sequences "Welch-10" and "Welch-16" as frequency coding sequences are used is considered.