Elektroerozyjne drążenie żarowytrzymałych stopów niklu
Journal Title: Zarządzanie Przedsiębiorstwem - Year 2016, Vol 0, Issue 2
Abstract
High demand for turbomachinery devices is constantly growing due to the constrains of reduction noise generation, fuel burn and gases emission. Competitiveness on the turbomachinery market forces manufactures to look for possibilities of reducing production costs using cost-effective machining methods. According to the safety requirements in area of aeronautical industry, it is very important to ensure high geometrical and dimensional accuracy. Because of the very good mechanical properties, high temperature resistance and corrosion resistance, hard to machine nickel based superalloys are commonly used as components of aero engines. Due to the mentioned properties it is very hard to machine heat resisting nickel alloys with conventional machining methods. One of the non-conventional machining methods which is commonly used is electrodischarge machining. The main advantage of this method is that it is possible to machine each material which is an electrical conductor, regardless of its mechanical properties. In this paper the results of electrodischarge drilling of Inconel 625 and Inconel 718 with different values of current intensity and pulse time were presented. There was pointed the relation between current intensity and material removal rate and also correlation between discharge intensity and material removal rate. On the basis of experiment results it is known that Inconel 625 is easier to machine by EDM than Inconel 718. As a result of SEM photos and EDS analysis of the Inconel 718 surface it is possible to say that discharge intensity growth results in occurring bigger and deeper electroerosion craters, microcracks and solidified debris with content of carbon. It is required to expand the research of analysis of changes in Inconels 625 surface.
Authors and Affiliations
A. Żyra
Keywords
Related Articles
- EP ID EP352923
- DOI -
- Views 43
- Downloads 0
Metodyka postępowania przy wprowadzaniu poziomowanej produkcji
This article presents an original methodology of implementation of repeatable production plan. After analyzing the available literature, both Polish and world, and their own thoughts, it was found that the available meth...
Modelowanie stanu warstwy wierzchniej za pomocą sieci neuronowych
The article presents result of residual stresses measured in the samples which were firstly subjected to peripheral milling. The samples were made out of difficult-to-cut materials (titanium based alloys Ti6Al4V and ni...
Elektroerozyjne drążenie żarowytrzymałych stopów niklu
High demand for turbomachinery devices is constantly growing due to the constrains of reduction noise generation, fuel burn and gases emission. Competitiveness on the turbomachinery market forces manufactures to look for...
Metody szacowania kosztów na etapie projektowania i kształtowania procesów produkcyjnych
On the stage of product design there is a problem related to production cost estimation in the moment when elements are not yet definitely designed. Depending on the amount of the available information, more or less prec...
Badanie wiadomości projakościowej pracowników na przykładzie wybranego przedsiębiorstwa
In the article the results of the researches of the conscio usness pro-quality employees on the example the chosen company are presented. The paper contains the theoretical and practical session. The theoretical session...