Estimation of the effect of temperature, the concentration of oxygen and catalysts on the oxidation of the thermoanthracite carbon material
Journal Title: Восточно-Европейский журнал передовых технологий - Year 2019, Vol 2, Issue 6
Abstract
<p>The effect of temperature, oxygen concentration and gas-air mixture flow rate on the oxidation efficiency of thermoanthracite carbon granular material with the formation of carbon monoxide and dioxide is considered. The modeled installation implies heating of the carbon material sample in a heat chamber with constant passing of the gas-air mixture obtained by adjusting the supply of air and carbon dioxide through the heating zone. The temperature range was 20–850 °C.</p><p>It is found that noticeable oxidation of carbon material in a heat chamber during purging of gas-air mixtures with an oxygen content of 8–21 % begins at temperatures above 500 °C, and significant concentrations of carbon monoxide are formed at temperatures of 600–800 °C. It is determined that, at an oxygen concentration of 14 %, the content of carbon monoxide in flue gases is minimal in the chosen range of oxygen concentrations of 8–21 %.</p><p>It is shown that the use of the gas mixture saturated with water vapor increases the efficiency of carbon monoxide reoxidation at temperatures of 650–850 °C, but when using the manganese catalyst, the catalytic effect of water vapor is not observed.</p><p>The use of the manganese catalyst applied as microcrystals on the carbon material surface is proposed, which provides a significant reduction of CO concentrations at temperatures of 500–850 °C. The disadvantage of the process is a 1.6–2.0 times increase in carbon material losses due to the acceleration of coal oxidation to CO and CO<sub>2</sub>.</p>The possibility to create certain conditions for the technological process of oxidation of thermoanthracite carbon granular material at enterprises to provide a reduction of the carbon monoxide content in oxidation products is presented
Authors and Affiliations
Yevgen Panov, Nikolai Gomelia, Olena Ivanenko, Andrii Vahin, Serhii Leleka
Keywords
Related Articles
- EP ID EP666317
- DOI 10.15587/1729-4061.2019.162474
- Views 71
- Downloads 0
Determining the force function distribution in the working zone of a disk magnetic separator
The paper reports a research into the distribution of magnetic force function in the working zone of a newly-designed disk separator, intended to clean the finely-dispersed bulk substances, transported by a belt conveyor...
Effect of the integrated treatment on the manufacturing of printing cylinders
<p>We have developed a comprehensive technology to strengthen printing cylinders by forming a regular microrelief at the surface followed by chromium-plating.</p><p>Our research into the influence of comprehensive machin...
Development of a selfdiagnostics subsystem of the informationmeasuring system using anfis controllers
<p>A hybrid self-diagnostic system was designed to evaluate correctness of functioning of sensors of the information-measuring system of testing hydraulic transmissions of diesel locomotives of UHP 750 type. The system f...
Interlaboratory comparisons of the calibration results of signal generator
<p>The data of interlaboratory comparisons of calibration results of signal generators at three calibration points are presented. The choice of methodology for processing the results of interlaboratory comparisons is mad...
Application of the new structural solutions in the seeders for precision sowing as a resource saving direction
<p>The study reported here provides a possibility to improve the reliability of conducting a technological process of dispensing the seeds, which affects the efficiency, that is, the cost of seed material, by introducing...