ESTIMATION OF THE SHAPE OF THE HYSTERESIS LOOP IN THE DEFORMATION OF CURRENT AND VOLTAGE OF THE TRANSFORMER
Journal Title: Informatyka Automatyka Pomiary w Gospodarce i Ochronie Środowiska - Year 2013, Vol 3, Issue 4
Abstract
The paper presents a new method for modelling transformer with a hysteresis loop by Jiles-Atherton. The Micro-Cap program allows the modelling of magnetically coupled coils by a description of the parameters of the magnetic circuit connecting the coil and the shape of ferromagnetic hysteresis. The way of determination of parameters describing the shape of the magnetization curve are presented, taking into account the phenomenon of ferromagnetic hysteresis. Simulations were performed by changing the values of induction remanence and coercivity magnetic field and a fixed value of the magnetic field strength, saturation induction, permanent magnetization and the designated voltage. Is an example of the results of numerical calculations.
Authors and Affiliations
Wiesław Brociek, Robert Wilanowicz
Keywords
Related Articles
- EP ID EP59499
- DOI -
- Views 91
- Downloads 0
HYBRYDOWA WYRZUTNIA ELEKTROMAGNETYCZNA Z MODUŁEM CEWKOWYM JAKO OGRANICZNIK PRĄDU W MODULE SZYNOWYM
Artykuł dotyczy udoskonalenia działa prototypu wyrzutni o oryginalnej konstrukcji, składającego się z modułu pneumatycznego, elektromagnetycznego modułu typu coilgun i elektromagnetycznego modułu typu railgun, nazwa...
TWO-MODULAR SYSTEM FOR PROCESSING EEG DATA USING FACTOR ANALYSIS AND MOORE-PENROSE PSEUDOINVERSION
This paper describes the concept of obtaining the so-called. the output signal for the purpose, inter alia, the control processes carried out. To this end, proposed the construction of two-modular system for processing a...
USING HYBRIDIZED TECHNIQUES TO DEVELOP AN ONLINE WORKPLACE RISK ASSESSMENT TOOL
Recent research has shown that work stress has become a widespread concern in Australia and other countries. It is a growing concern across all employment sectors as well as occupational levels and reported as a common c...
USE OF THE PID CONTROLLER TO CONTROL OF THE PARARELL KINEMATIC MANIPULATOR WITH ELECTROHYDRAULIC SERVO DRIVES
The article describes the use of the PID controller to control the manipulator equipped with electrohydraulic drives. The design of the manipulatora was based on an unusual parallel kinematics, in which arm movements are...
USING THE GPU TO DETERMINING THE AREA THE FLAME IN THE VISION DIAGNOSTIC SYSTEM
This paper presents possibility of using GPU to determine the edge of the image pulverized combustion coal. Compared are the operation time and the accuracy of edge detection area of the flame. Used a method based on the...