EVALUATION OF OPPORTUNITY BIOMEPEDOMSOMETRY FOR MONITORING OF ULTRAFILTRATION PROCEDURE
Journal Title: Вчені записки Таврійського національного університету імені В. І. Вернадського. Серія: Технічні науки - Year 2018, Vol 29, Issue 4
Abstract
The research aimed at developing and approbation of the modified method of covariance analysis of the BIM signal for solving the problems of information support of the ultrafiltration procedure in real time mode is carried out. The modification of this method is based on the use of bioimpedance measurements at different frequencies as multiple measurements in one time coordinates. The aim of the study was to obtain additional information, primarily on the relative rate of measurement of fluid volumes of the vascular bed and intercellular fluid. In the article the mathematical substantiation of the modification of the classical covariance analysis method is given, the table of covariance decomposition is given, the model of this decomposition is proposed taking into account the influence of the factor on the signal trends. Two methods of preliminary data preparation for using the new method are also proposed, which allow to investigate the local part of the procedure (scan) or to take into account the entire previous history from the moment of the procedure start (accumulation). Approximation of the developed method on the experimental data obtained during the ultrafiltration procedures of 7 patients was carried out, which showed the effectiveness of this method of control in 79% of cases with a confidence of 0.95. Also in the work, an evaluation of the effectiveness, based on the experimental data, of the developed method on the classical covariance analysis was carried out. Efficiency evaluation showed an increase in the amount of information in the experiment, using the new method, 2.68 times and 2.07 times, using scanning or accumulation techniques, respectively.
Authors and Affiliations
Р. С. Томашевский
ANALYSIS OF THE INTERACTION OF THE EDUCATIONAL DISCIPLINES CONTENT BY THEIR SEMANTIC DESCRIPTION
The purpose of this work is to study existing approaches to the description and construction of ontologies, especially in the domain of academic disciplines and methods for automating the presentation of domain knowledge...
THE SYSTEM FOR CONTROL OF VVER-1000 FUEL PROPERTIES WHEN KEEPING THE COOLANT TEMPERATURE CONSTANT
The necessity of the development and introduction of the automated control system of nuclear fuel properties during the operation of the WWER-1000 type reactor with the constant average temperature of the heat carrier of...
DETERMINATION OF BARJES PARAMETERS FOR THE TRANSPORT OF LONG RAILS
It is proposed to select the parameters of the vessel from the swimming pool in order to form a fleet for technological transport. Improving transport conditions by branching out transport infrastructure. Construction of...
GRASPING OF NOVEL OBJECTS BY MOBILE ROBOT USING VISUAL PROCESSING
The article describes the problem of capturing unseen before objects by a mobile robot, equipped with one camera without additional depth sensors. The basic properties of such robot system are determined. The method of o...
INVESTIGATION OF THE INFLUENCE OF MALFUNCTIONS OF SYSTEMS AND MECHANISMS OF DIESEL ON ITS ECOLOGICAL, ENERGY INDICES AND TEMPERATURE OF EXHAUST GASES
Determination of the list of parameters that allow for comprehensive diagnostics of engines, constitute one of the main tasks of diagnosing diesel engines. The analysis of the research shows that the temperature of the e...