EVALUATION OF SELECTED PROPERTIES OF A SURFACE LAYER AFTER MILLING USING INSERTS WITH DIFFERENT COATINGS
Journal Title: Tribologia - Year 2017, Vol 272, Issue 2
Abstract
The article presents a comparison of results of measurements of the geometrical structure of milled surfaces with inserts with different coatings. The study was done on a vertical milling centre. The first step was to determine the properties of milled surfaces using new inserts. For this purpose, an optical apparatus was used. The samples were then subjected to continuous treatment. Upon completion of the declared quantities of machining cycles, these surfaces were analysed. This allowed us to determine the influence of the coating of the inserts on the surface layer of milled surfaces continuously.
Authors and Affiliations
Piotr MAJ, Edward MIKO
Keywords
Related Articles
- EP ID EP239704
- DOI -
- Views 80
- Downloads 0
SELECTION CRITERIA FOR THE TOOTH MATERIAL IN THE CONTEXT OF THE APPLIED FINISHING TREATMENT OF CASE HARDENED AND QUENCHED TEETH
The issues are addressed relating to the selection of material to make gear teeth, depending on the applied finishing treatment techniques. Gear teeth considered in the study are those used in driving systems in earthmov...
INFLUENCE OF EROSIVE PARTICLES IMPACT ANGLE ON EROSIVE WEAR INTENSITY OF POLYURETHANE COATINGS
The article presents examination results of the influence of alundum particle impact angle on the kinetics of the erosive wear of polyurethane coatings. Examined three-layer polyurethane coatings of an average thickness...
Ocena oddziaływań pomiędzy ekologicznym dodatkiem smarnym i dodatkami przeciwutleniającymi w syntetycznej bazie olejowej
Przedstawiono wyniki badań właściwości smarnych i termooksydacyjnych dwui trójskładnikowych kompozycji smarowych na bazie syntetycznego oleju estrowego, uzupełnionych dodatkami o charakterze smarnym (PE) oraz przeciwutle...
Właściwości powłok Ni-Mo nakładanych metodą elektrochemiczną
W artykule przedstawiono badania powłok Ni-Mo osadzanych metodą elektrochemiczną. Analizowano właściwości mechaniczne i tribologiczne powłok Ni-Mo wytwarzanych przy gęstościach prądu osadzania z zakresu 0,5–5 A/dm2. Bada...
THE TRIBOLOGICAL PROPERTIES OF DLC COATINGS LUBRICATED WITH THE BIODEGRADABLE CUTTING FLUID
This paper presents the tribological results of diamond-like carbon DLC a type of a-C:H coating deposited on SW7M steel using the technique of chemical vapour deposition CVD. An observation of the coating structure was c...