Examples of material solutions in bimetallic layered castings
Journal Title: Archiwum Odlewnictwa - Year 2011, Vol 11, Issue 3
Abstract
In paper is presented technology of bimetallic layered castings based on founding method of layer coating directly in cast process so-called method of mould cavity preparation. Prepared castings consist two fundamental parts i.e. bearing part and working part (layer). The bearing part of bimetallic layered casting is typical foundry material i.e. pearlitic grey cast iron, whereas working part (layer) is depending on accepted variant plates of alloy steels sort X6Cr13, X12Cr13, X10CrNi18-8 and X2CrNiMoN22-5-3. The ratio of thickness between bearing and working part is 8:1. The verification of the bimetallic layered castings was evaluated on the basis of ultrasonic NDT (non-destructive testing), structure and macro- and microhardness researches.
Authors and Affiliations
T. Wróbel, M. Cholewa, S. Tenerowicz
Keywords
Related Articles
- EP ID EP72277
- DOI -
- Views 106
- Downloads 0
Preliminary Research on Granulation Process of Dust Waste from Reclamation Process of Moulding Sands with Furan Resin
The results of investigations of the granulation process of foundry dusts generated in the dry mechanical reclamation process of used sands, where furan resins were binders are presented in the paper. Investigations conc...
Influence of water-glass grade and quantity on residual strength of microwave-hardened moulding sands. Part 2
The paper continues dealing with the issues of influence of microwave hardening on mechanical properties of waterglass-based moulding sands. This second part of the research includes examining moulding sands containing 1...
Measurement of large-size casting geometry of the CMM
The aim of this paper is to present the geometric dimensions’ control of large castings and moulds on coordinate measuring machines (CMMs). Precise measurements of large components are connected with many problems that a...
MAGMAsoft simulation applied in verification of technology to produce new range of alloy steel castings
The article presents the results of MAGMAsoft application in simulation of the pouring and solidfication of castings made from GS20Mn5 steel, basing on some principles adopted in the starting technology. The results of s...
Influence of vibrations during crystallization of EN AC-ALSi13Cu2 alloy on mechanical and porosity properties
Today’s industry aims at such situation, where number of defective products, so called defects shall approach to zero. Therefore, one introduces a various changes in technology of production, introduces improvements whic...