EXPERIMENTAL INVESTIGATION OF PERFORMANCE AND EMISSION CHARACTERISTICS OF AN IDI DIESEL ENGINE USING HOMOGENIZED WATER IN DIESEL EMULSION
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2018, Vol 8, Issue 3
Abstract
A comparative experimental study on a 1.8L IDI diesel engine has been carried out to evaluate the influence of homogenized water in diesel emulsion on performance and exhaust emissions against base fuel diesel. The emulsions tested were diesel fuels by 5%, 10% and 20% by volume of water. Experiments were conducted at full load condition and during testing; the engine speed was maintained in the range of 1000 to 4000 rpm and varied in steps of 500 rpm. Emission parameters NOx, CO, were measured. Reduction in exhaust temperature and smoke opacity was observed with all the tested emulsions. Contradictorily, NOX was found to be increasing with increase in water content which might be an outcome of a very weak or absence of the microexplosion phenomenon. Power was reduced, while specific fuel consumption of water in diesel emulsions was found to be higher than diesel.
The Best Impact of Small Medium Enterprises in Scale Industries – An Over View
The Small and Medium Scale of Enterprises (SMEs) is being very unpredictable in nature takes high quantity of risk. It is consequently it’s very important for them to address the indecision through reliable and loyal emp...
Engine Performance and Emission Characteristics of 1-Octanol Blended Bio-Diesel in a Single Cylinder Diesel Engine
Experiments were carried out on a diesel engine operating on diesel, bio-diesel and bio-diesel blended with 1- octanol. The blended fuels are prepared with 10%, 20%, and 30% of 1-octanolby volume. The experiments were co...
Automatic Rebalancing of Radial Gates of the Spillway Dam in Cameroon
One of the problems facing hydroelectric plants is the imbalance of radial gates of the spillway dam. This imbalance causes the deterioration of lateral guiding seals, the deterioration of thermal relays, the deteriorati...
A Power Efficient Multiplier Architecture for FIR Filters used for Acoustic Models in Mechanical Diagnostics
Finite Impulse Response (FIR) channels are broadly utilized as a part of multi standard remote interchanges. The important pre requisites of channels are re configurability and low many-sided quality. This paper proposes...
CFD Analysis on Buble Growth and Bubble Departure in Pool Boiling
The process of bubble nucleation, growth and detachment are simulated using volume fraction method. As the bubble grows to a certain size, it will eventually detach from an active nucleation site, especially for the case...