Experimental Investigation on Fully Replacement of Steel Slag as Course Aggregate in M30 Grade Concrete
Journal Title: International Journal for Research in Applied Science and Engineering Technology (IJRASET) - Year 2017, Vol 5, Issue 2
Abstract
Slag is co-product of the iron and steel making process. The use of steel slag reduces the need of natural rock as constructional material, hence preserving our natural rock resources, maximum utilization and recycling of by-products and recovered waste materials for economic and environmental reasons has led to rapid development of slag utilization. The use of steel aggregate in concrete by replacing natural aggregates is a most promising concept. An attempt was made to replace coarse aggregate with the steel slag. When it was cut to a required size of 20 mm and less. This steel slag with different percentage of 25%, 50%, 75%, 100%, was tested for partial replacement of coarse aggregate for M30 grade concrete. The compressive strength of steel slag with 25% replacement was found to have 40.4 N/mm2 at the end of 28 days Which is marginal to the conventional concrete. The split tensile strength of fuel dispenser hose pipe with 10% replacement was 5N/mm2 at the end of 28 days which is more than conventional concrete. The flexural strength of fuel dispenser hose pipe with 10% replacement was 5N/mm2 at the end of 28 days which is more than conventional concrete. Hence 10% of fuel dispenser can be replaced for coarse aggregate in cement concrete.
Authors and Affiliations
J. Vengadesh Marshall Raman, M. Sriram
Keywords
Related Articles
- EP ID EP23126
- DOI http://doi.org/10.22214/ijraset.2017.2037
- Views 258
- Downloads 6
Automatic Disfluency Identification and Recognition from Conversational Speech
Speech is the central mechanism that supports daily communication with others and plays an important role in establishing and sustaining social relationships. Stuttering disrupts normal flow of speech and interferes wit...
Design and Implementation of Pyramidal Horn Antenna
This technical paper presents design and implementation of pyramidal horn antenna. Antenna is a transducer used to convert electrical signals into electromagnetic waves i.e. radio waves. Horn antenna supports wide range...
A Review Report For Study of Drilling For Different Materials In Machining
Metal drilling processes are important due to increased consumer demands for quality metal drilling related products reduce tool wear and better product surface roughness that has driven the metal drilling industry to c...
Development of a Mathematical Model for Kinematic Analysis of a Crusher Mechanism Using Matlab as a Tool
Objective of this thesis is to develop a mathematical model for a crusher mechanism, which can calculate Kinematic Parameters like Velocity and Acceleration of any point on Jaw Link of a crusher which in turn is require...
Design of high speed low power Content Addressable Memory (CAM) using parity bit and gated power matchline sensing
Content Addressable Memory (CAM) offers high speed search function in single clock cycle. Due to its parallel matchline comparison, Content Addressable Memory power is hungry. In general CAM has three operation modes re...